Publicité
Les langues disponibles
Les langues disponibles
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Tape measure
■
1/4" (6.3 mm) nut driver
■
Parts supplied
Foam strip roll
■
Clamping brackets (2)
■
Parts needed
A UL listed or CSA approved connector for 1/2" (1.3 cm)
■
diameter conduit
UL listed wire connectors
■
Check local codes. Check existing electrical supply. See the
"Electrical Requirements" section.
It is recommended that all electrical connections be made by a
licensed, qualifi ed electrical installer.
2
E P
✵ ✁ ✂
✁ ✄ ✵ ☎ ✆ ☎ ✝ ✞ ✵ ✟ ✞ ✵ ✠ ✡ ☛ ☞ ✌ ✠ ✍ ✠ ✎ ✂ ✠ ✡
COOKTOP SAFETY
Your safety and the safety of others are very important.
DAN GER
WARN I N G
INSTALLATION REQUIREMENTS
Marker or pencil
■
Pliers
■
Flat-blade screwdriver
■
2½" (6.4 cm) clamping
■
Screws (2)
■
In some European factories the letter "W" of the part code mentioned herein will be automatically
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
When installing cooktop, use minimum dimensions given.
To eliminate the risk of burns or fi re by reaching over the
■
heated surface units, cabinet storage space located above
the surface units should be avoided. If cabinet storage is to
be provided, the risk can be reduced by installing a range
hood that projects horizontally a minimum of 5" (12.7 cm)
beyond the bottom of the cabinets.
The cooktop must be a specifi ed cooktop that is approved
■
to be installed either alone or over an undercounter built-in
oven. Check the cooktop base for an approved installation
label. If you do not fi nd this label, contact your dealer to
confi rm that your cooktop is approved.
The cooktop must be installed in a level countertop.
■
Ovens approved for this type of installation will have an
■
approval label located on the top of the oven. If you do
not fi nd this label, contact your dealer to confi rm that your
oven is approved. Refer to oven manufacturer's Installation
Instructions for approval for built-in undercounter use and
proper cutout dimensions.
The cooktop should be installed away from strong draft
■
areas, such as windows, doors, fans or strong heating vents.
The cooktop should be located for convenient use in the
kitchen.
Use the countertop opening dimensions that are given
■
with these Installation Instructions. Given dimensions are
minimum clearances and provide 0" (0 cm) clearance.
Grounded electrical supply is required. See "Electrical
■
Requirements" section.
IMPORTANT: To avoid damage to your cabinets, check with
your builder or cabinet supplier to make sure that the materials
used will not discolor, delaminate, or sustain other damage.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Publicité
