Yakima LowRider MAX CLAW-2 Instructions D'installation page 4

TeST The
InSTALLATIon:
grab the bar near the
towers and pull up,
back and forth.
Install rear towers and bars.
Position rear towers and bar on the roll cage.
Jeep Wrangler
2002-2006
Jeep Wrangler
1997-2001
Place rear towers and
bars on the rear section
of the roll cage. you
may have to push the
roll cage cover back.
repeat steps 6 through 8 to tighten, secure,
and test installation of rear towers.
1033351C-/12
Maximum Crossbar
spread = 28"
installed over front
doors only.
or
maximum = 48"
If A toweR sLIdes oR LIfts
AwAy fRoM the bAR, repeat
the tightening process until
the tower is secure.
CroSSBAr SPreAD:
The distance between the Yakima crossbars is
determined by the accessories you wish to carry. The
Crossbar Spread Table will tell you how much crossbar
spread your accessories require.
(refer to your yakima dealer,
or go online at www.yakima.com)
minimum = 19"
refer to LowRider Max instruction (yakima Part # 1033347)
for care and maintenance.
K E E P T H E S E I N S T R U C T I O N S !
There must be no
contact between
tower pad, CLAW-2,
and the roll cage
padding!