Ariston TVF63 Livret D'entretien page 6

Start and Programs
Choosing a program
EN
1. Plug the dryer into the electrical socket.
2. Sort your laundry according to fabric type (see
Laundry).
3. Open the door and make sure the filter is clean
and in place (see Maintenance).
4. Load the machine and make sure that the items
are not in the way of the door seal. Close the door.
5. If the On/Off light is not lit: Press the On/Off
button .
6. Choose a program by checking the Programs guide
(see Programs) as well as the indications for each
type of fabric (see Laundry).
- Select a program by rotating the PROGRAMS knob.
7. Set a delay time and other options if necessary.
8. The Start/Pause light is flashing green, press the
Start/Pause button
stops flashing and the display will show the
estimated time to end.
Jeans Program
This is a program for Jeans made from Denim Cotton. Before drying your Jeans turn the front pockets inside out.
It can be used for load sizes up to 7 lbs (3 kg) (approximately 4 pairs).
Do not mix dark and light colored items.
It can also be used on other garments made from the same material such as jackets.
This program will take about 100 minutes, but may take longer depending on the size of the load and the spin
speed used in your washer.
Loads dried using this program are usually ready to wear:- the edges or seams may be slightly damp. If this is
found try turning the jeans inside out and running the program again for a short period.
! We do not recommend that you use this program if your jeans have elastic waist bands, studs or embroidery.
Active Wear Program
This program is to dry up to 4 lbs (2 kg) of outerwear and as part of the drying process; it re-activates the
fluorocarbon-based water resistance (also known as DWR durable water resistance). It can also be used to
activate the fluorocarbon finish where the garment has been re-proofed (see the proofing agent manufacturer's
instructions).
This program can also dry outerwear without a fluorocarbon finish.
The program dries the items and then runs for a further period of heating at 120˚F (50˚C) to activate the
water-resistant coating.
The last 15 minutes of the program is a cool tumble period, without heat, and this stage should always be
completed.
If proprietary proofing agents are used during washing, always follow the manufacturer's instructions.
Wool Program
This is a program for tumble dryer safe garments marked with the symbol
It can be used for load sizes up to 2 lb (1 kg) (approximately 3 sweaters).
We recommend that garments are turned inside out before drying.
This program will take about 60 minutes, but may take longer depending on the size and density of the load
and the spin speed used in your washer.
Loads dried using this program are usually ready to wear, but on some heavier garments the edges may be
slightly damp. Allow these to dry naturally as over-drying could damage garments.
! Unlike other materials, the mechanism of wool shrinkage is irreversible; i.e. it will not stretch back to original
size and shape.
! This programme is not suitable for Acrylic garments.
6
All manuals and user guides at all-guides.com
to begin. The green light
During the drying program, you can check on
your laundry and take out the items that are dry
while others continue drying. When you close
the door again, press the Start/Pause button
in order to resume drying.
(When the door is open the Start/Pause light will
flash amber and after the door is closed and the
Start/Pause button pressed will stop flashing and
show green).
9. During the last few minutes of Drying Programs,
before the program is completed, the final Air Fluff
phase is entered (fabrics are cooled), this phase
should always be allowed to complete.
10. The buzzer (alert) will warn you when the program is
complete. Open the door, take your laundry out,
clean the filter and replace it (see Maintenance).
If the Post Care Option has been selected and
you do not take the clothes out immediately, the
clothes will tumble occasionally for 10 hours or
until you open the door.
11. Unplug the dryer.
.