SAMES KREMLIN PRIMA 01D100 Mode D'emploi page 106

DocuSign Envelope ID: 58226A3B-6A43-45B5-87C1-59BD313EA5BA
The manufacturer herewith declares that the equipment is in conformity with the UK statutory requirements.
(1)
(2) Equipment type
(3) Applicable
Directives
(9) Approved body
(10) This partly completed machinery must not be put into service until the final machinery in which it
is to be incorporated has been declared in conformity with Supply of Machinery (Safety) Regulations
2008.
Sames is allowed to compil the technical documentation.
Sames undertakes to transmit, in response to a reasoned request by the national authorities, relevant
information on the partly completed machinery in the most appropriate form. This declaration of
incorporation of partly completed machinery and this declaration of conformity are issued under the
sole responsibility of the manufacturer.
Director of the STAINS site - Executive Management (EM)
Hervé WALTER
Established in Stains, on
Siège Social / Headquarter: 13, chemin de Malacher - CS70086 - 38243 Meylan Cedex - France - Tél / Phone: +33 (0)4 76 41 60 60
(4) The relevant technical documentation was compiled as
The essential health and safety requirements mentioned in Supply of
2008 No. 1597
Machinery (Safety) Regulations 2008 have been applied.
Articles: 1.1 , 1.1.2 ,1.1.3, 1.1.5 , 1.2 , 1.2.2, 1.2.3, 1.2.4, 1.2.4.1 , 1.2.4.3 ,
1.2.6, 1.3 ,1.3.1, 1.3.2, 1.3.3, 1.3.4, 1.3.6, 1.3.7, 1.5, 1.5.2, 1.5.3, 1.5.4, 1.5.5,
1.5.6, 1.5.7, 1.5.8, 1.6, 1.6.1 , 1.6.2, 1.6.3, 1.6.4, 1.7, 1.7.1, 1.7.2
(5) That partly completed machinery is also in conformity with the provisions of
(6) Marking
2016 No. 1107
(7) Designated
standards
(8) Conformity
assessment
procedure
CLM 2503 - Ellesmere Port - United Kingdom
/ CML n° 22UKEXT288 Issue 0
18/04/2023
SAS au capital de 12.720.000 euros | RCS Grenoble: 572 051 688 | Code APE: 2829B | TVA intracom: FR36 572051688
DECLARATION OF INCORPORATION
OF PARTLY COMPLETED MACHINERY
UK DECLARATION OF CONFORMITY
PNEUMATIC DIAPHRAGM PUMP
PRIMA TM 01D100
specified in annex VII, part B.
Pump
II 2G Ex h IIB T6 Gb X
Ex h => Protection par sécurité de construction (c) /
Protection by constructional safety (c)
Conditions spéciales d'utilisation, le signe X indique de se
référer aux prescriptions figurant dans le manuel d'instructions
qui accompagnent le produit.
- Specific conditions of use, X indicates to refer to the
prescriptions specified
accompanies the product.
EN ISO 80079-36 : 2016
EN ISO 80079-37 : 2016
EN 1127-1 : 2019
Module A Technical documentation (Annex VIII)
Sames
1
in the instructions manual
DEC UK 578154130
that