Hisense RL415N4ACE Manuel D'instructions page 15

15
replacing the shelves
Thoroughly dry all surfaces and removable
parts before putting them back into place.
Caution!
Do not use sharp objects to remove frost
from the freezer compartment. Only after
the interior is completely dry should the
appliance be switched
plugged back into the mains socket.
Door seals cleaning
Take care to keep door seals clean. Sticky
and baskets. food and drinks can cause seals to stick to
the cabinet and tear when you open the
door. Wash seal with a mild detergent and
warm water. Rinse and dry it thoroughly
after cleaning.
Caution! Only after the door seals are
completely dry should the appliance be
powered on
Replacing the LED light:
This product contains a light source of
energy efficiency class F.
Warning:
The LED light should be replaced by a
competent person. If the LED light is
damaged, contact the customer helpline
for assistance. To replace the LED light,
the below steps can be followed:
1. Unplug your appliance.
2. Remove light cover by pushing up and
out.
3. Detach the LED and pull it while
back on and pressing the connector latch.
4. Replace LED light and snap it correctly
in place.