Ascaso BARCELONA BABY T Manuel De L'utilisateur page 15

7 - Hydraulic connection
IMPORTANT!
This equipment is to be installed with adequate backflow protection to comply
with aplicable federal, state, and local codes.
This machine has different connection options, either to the MAINS or the RESERVOIR,
depending on the model, whether ZERO or PLUS. Before starting it up, check the
model of your machine.
The Baby T ZERO only has the option of using
water from the RESERVOIR. You will find this
on the right-hand side of the machine. To start
it up:
1. Fill the reservoir with fresh water.
2. Check that the water inlet pipe is fully
submerged in the reservoir.
3. Check that the reservoir is filled with
enough water. If you operate the coffee
machine without water, it can damage the
pump.
IMPORTANT!
The machine has an electronic water level control in the reservoir; once the water
has gone below the minimum level, a warning light will appear (see Section 12).
We recommend using water with a low mineral content. The quality of the water
affects the flavour and quality of the coffee, and also helps to prevent malfunctions
in the future. Check out our special anti-limescale filters (optional).
Recommended water parameters for using with a mains connection:
T.D.S.
Total hardness
Total iron
Free chlorine
Total chlorine
90-150 ppm
70-100 ppm
0-0.22 ppm
0-0.05 ppm Mains pressure
0-0.1 ppm
pH
Alkalinity
Chlorine
0,1/1,0 MPa
Flow rate
6.5-8
40-80 ppm
0-30 ppm
8 l/min
15