Publicité
Les langues disponibles
Les langues disponibles
FAULTS
If the appliance does not work properly, this does not always mean
that it is defective. Try to deal with the problem yourself first by
checking the points mentioned below:
Fault
After the appliance has been electrified, text
appears in the displays.
After the appliance has been switched on, the fuse
in the meter cupboard blows.
The fan keeps on running after the appliance has
been switched off.
The hob does not work and the lights are not on.
After the zone has been switched on, the zone
displays continue to flash.
While cooking, you hear a rattling noise in the
base of the pan.
When you use the hob the first time, you notice
that it smells 'new'.
You hear a ticking sound in your hob.
The cooking zone suddenly stops during use. You
hear a beep.
Failure code F00...F08
Failure code FA
Failure code F0...F6
Failure code F8
Failure code F9
Failure code F99
Continuous beep.
122
All manuals and user guides at all-guides.com
Probable cause
Solution
Normal operation.
NOTHING: see chapter "building in" in
the installation part of this manual.
Appliance incorrectly connected.
Check the electrical installation.
The electronic circuits inside the hob are
This is normal.
being cooled.
The appliance has been connected
Check the electrical installation (main
incorrectly or the mains voltage is not right.
fuse(s) or the connection).
After the zone has been switched on, the
See chapter
zone displays continue to flash.
"Comfortable cooking".
The noise is due to the high power of the
This is normal for some pans on higher
cooking zone having an effect on the base of
settings. It is harmless for the induction hob.
the pan.
This is caused by the appliance's finish
The odour will disappear of its own accord
heating up. It is perfectly normal.
as a result of ventilation.
This is caused by the appliance switching
This is normal.
over from the rear cooking zone to the front
one and back again or if you choose a low
setting.
The time programmed has expired.
Switch the beep off by pressing the + or -
button of the timer.
A button was pressed too long or there is an
Remove the object. Switch on the appliance
object or water on top of it.
again.
The appliance has been connected
Check the connection. Contact your energy
incorrectly or the mains voltage is too low.
supplier if the problem remains.
Defect of generator.
Contact the service department.
Appliance over heated.
The appliance has been switched off because
of over heating. Let the appliance cool down
and start again on a lower setting.
The appliance has been connected
Modify you're your connection.
incorrectly or the mains voltage is too high.
You have pressed two buttons at the same
Do not operate more than one button at the
time.
same time.
The appliance has been connected
Let your connection be changed.
incorrectly or the mains voltage is not
right.
table
FAULTS
In case of faults phone the service department. See the guarantee
certificate or consult the internet site www.hps.nl.
If you notice a crack on the cooking surface (no matter how little),
switch off the appliance immediately. Remove the plug from the
socket or set the switch of the power supply cable (in the case of a
fixed connection) to zero or turn off the fuse switch(es) in the meter
cupboard. Phone the service department.
This appliance should only be connected up by a registered electrical
installer!
The electrical connection must comply with national and local
regulations.
Damage caused by incorrect connection, incorrect use or incorrect
building in is not covered by the guarantee.
general
123
Publicité
