Gorenje IT64ASC Notice D'utilisation page 29

Power management for a
limited power cooking
hob (ECO)
Induction plate
Ø (mm)
Level
0
1
2
3
4
5
6
7
8
9
P
Safety functions and error display.
ERROR
CODE
r See "Power management for a limited power cooking hob
(ECO)" pag.29
u See "Pan sensor" pag.26
See "Remaining heat indicator" pag.26
H
c Induction generator overtemperature
Induction heater overtemperature
C
FA Anomaly of infrared signal of the on/off key - all cooking
zones are deactivated
FC On/off button infrared receiver anomaly - all cooking zones
are deactivated
FE Touch control ntc sensor: short circuit on ntc sensor.- all
cooking zones are deactivated
FT Touch control ntc sensor: ntc sensor opening - all cooking
zones are deactivated
Fc Touch control ntc sensor: ntc sensor overheating - all cooking
zones are deactivated
All manuals and user guides at all-guides.com
The sequence to finish recording the new cooking hob power limit is :
▪ Simultaneously touch (C of heater 1) and (C of heater 4) keys.
▪ Once this is done, new cooking hob power limit is recorded and there is a
system reset.
To finish without recording the changes:
If there is no action in 60 seconds, changes are not recorded and there is a
system reset
For reduced power consumption, each time the user tries to increase the power, the
total power level of the cooking hob is calculated. If this total power level is greater
than the cooking hob power limit, the power increase is not allowed. An error beep
sounds and the heater display shows the actual power level and an 'r' blinking.
1-3 2-4
210 145
Power (W)
0 0
100 75
200 150
300 300
500 400
700 500
900 600
1100 800
1300 1000
1500 1200
2000 1600
ERROR DESCRIPTION INSTRUCTION MANUAL
Switch the hob off and the oven installed
underneat it until they cool down
completely. Turn on the hob to check all
functions. If the problem remains Contact
authorized center for technical assistance -
specify the error code
Switch the hob off and the oven installed
underneat it until they cool down
completely. Turn on the hob to check all
functions. If the problem remains Contact
authorized center for technical assistance -
specify the error code
Contact authorized center for technical
assistance - specify the error code
Contact authorized center for technical
assistance - specify the error code
Contact authorized center for technical
assistance - specify the error code
Contact authorized center for technical
assistance - specify the error code
Switch the hob off and the oven installed
underneat it until they cool down
completely. Turn on the hob to check all
functions. If the problem remains Contact
authorized center for technical assistance -
29