Publicité
Les langues disponibles
Les langues disponibles
Displaying power levels
Power Management
Setting of a power limit
for cooking hob
All manuals and user guides at all-guides.com
Level
1
10
Max. time on (hours)
Example:
Set the cooking zone to power level 5 and let it operate for some time. If you
don't change the level, the safety mechanism will switch off the cooking zone
after 10 hours.
Protection against overheating
Induction cooking hob is also fitted with safety device against overheating which
protects electronic parts from damages. This device operates on several levels.
When cooking zone temperature increases excessively, the two-stage fan is
switched on first. If this is not enough, extra powerful heating is deactivated; and
finally, the safety device either reduces the heating power of certain cooking
zones or turns them off completely. When the cooking zone cools down, the full
power of the cooking zone is again available. So during the operation, you can
hear a steady hum due to the activated cooling fan. It is possible that the cooling
fan continues to operate even after the cooking hob was switched off.
Power level 0:
A constant "0" is displayed on the heater display. If the induction generator
indicates residual heat, the display alternates between "0" and "H". This
indication only disappears when there is no longer any danger (at 55° C).
The display shows a "0" as long as the temperature remains below 55° C,
whereas it shows an "H" whenever the temperature exceeds 55° C.
To save energy, turn off the burner in advance in order to exploit the residual
heat.
Power level 1...9, P:
If no pan is detected or if an aluminium pan is detected, the power level flashes
on the heater display. After 30 seconds, if a non-aluminium pan is not detected,
the power level returns to 0.
When a non-aluminium pan is detected, the power level is shown constant on
the heater display.
In cases where the cooking hob is already in operation for some time, to change
the limit of power, before proceeding with programming, unplug it, then reinsert
the plug after a couple of minutes.
The power drawn is 2800 W, but you can increase it to 3500 W, 6000 W or
7200W.
The sequence to set a new cooking hob power limit is as follows:
▪ During the first 30 seconds after plugging in the appliance.
▪ The touch has to be unlocked and all heaters must be switched off.
▪ Simultaneously touch (C of heater 1) and (C of heater 4) keys.
▪ Once this is done, a beep sounds and "Po" Characters will be in the timer
display; the "actual Cooking hob Power Limit" will be in the display 1 and in the
display 4.
To selecting a new power limit:
▪ Use the (B+) or (B-) keys to increase/decrease the power limit. The selectable
powers are: 2800W, 3500W, 6000W or 7200W.
2
3
4
5
6
7
10
10
10
10
10
10
8
9
10
3
28
Publicité
