UPPAbaby G-LITE Mode D'emploi page 4

STroLLEr ASSEMBLY
ATTACHING THE
froNT WHEELS
STEp 1
Slide front wheels onto frame STEp 1: Release the latch lock on the left side of the frame and
until an audible "click" is heard. unfold the stroller.
STEp 2: Rest stroller on back wheels and push down pedal
(with your right foot) on the back of stroller while pulling both
handles up towards you.
STEp 3: Make sure each lock "clicks" to indicate that the frame
is fully open.
SETTING/rELEASING
THE BrAKE
STEp 1
To SET BrAKE: Press down
each foot pedal to lock.
To rELEASE BrEAK: Lift up
on each foot pedal.
UPPAbaby G-LiTE Instruction Manual
All manuals and user guides at all-guides.com
opENING STroLLEr
STEp 2 STEp 3
CLICK
ATTACHING THE CANopY
STEp 2 STEp 3
STEp 1: Slide canopy onto frame just below
mesh attachment and above plastic stud.
STEp 2: Press down lever to lock canopy open.
STEp 3: To secure canopy, attach Velcro tabs
around stroller frame.
Extend SPF 50 pop-out sun canopy for extra
protection against UV rays.
5
STEp 1: Collapse the canopy by
lifting up levers.
STEp 3: Simultaneously insert middle
finger into release ring on both sides
of stroller and lift to release.
STEp 1: Undo buckle and slide
harness fastener off.
2
STEp 4: Remove top of pad.
1
1 30C
2
1
Machine wash seat pad
CLEANING
separately in cold water on
2
gentle cycle with mild detergent.
STroLLEr opErATIoN
foLDING THE STroLLEr
STEp 2: Engage safety button on
right side trigger
STEp 4: Pull the front wheels and
footrest up towards you.
rEMovING THE SEAT pAD
STEp 2: Undo top Velcro strips.
STEp 5: Remove bottom of pad.
Dry flat and away from direct
sunlight before re-use or storage.
6
STEp 5: Engage the locking
mechanism in standing position.
STEp 3: Push harness straps and
buckles through hole in pad.
Do NoT bleach, iron
or dry clean.
ENGLISH