Publicité
Les langues disponibles
Les langues disponibles
6
Position downrod so the hole in the downrod aligns with the hole in the
coupling on the motor. Insert safety bolt (S7) through coupling and
downrod and attach nut. Tighten firmly. Tighten set screw "A" against
downrod. For BC & OPXL Series place flange cover (4) over downrod
assembly until it covers flange. Place canopy (3) over downrod (2).
Replace hanging ball, insert hanging pin through downrod and tighten
set screw "C" in hanging ball into downrod.
NOTE: Flange cover will not work with supplied 2 1/2 inch downrod. Flange cover is
decorative and will not affect the operation of the fan.
ThreadedSet
Screw Hole
Ground
Hanging
Wire
Pin
BallS
Hanging
crew
Ball
Safety Bolt
and Nut (S7)
WARNING: Failure to completely tighten downrod as described in steps
5 & 6 above could result in the fan loosening and possibly falling.
Step 6
Set Screw (C)
Downrod (2)
Canopy (3)
Flange Cover (#4)
(if included in parts list)
Set Screw (A)
Motor Housing (5)
7
For added security, attach safety cable from fan unit to "J" hook (S9) in
outlet box. Secure by looping zip tie (S10) through safety cable and "J"
hook. Tighten zip tie securely. Lift fan onto the mounting bracket (#1).
Turn housing until hanging ball seats itself into ball socket (listen for click).
Green Ground Wire
NOTE: Parts furnished will allow
you to install your fan at up to a
35∞ angle. Angles greater than
35∞ will require a 45∞ angle
adapter (see dealer). NOTE: J
Hook installation is a Canadian
requirement only.
WARNING: To reduce the risk of fire, electric shock or personal injury,
mount so outlet box marked "acceptable for fan support" and use mounting
screws provided with the outlet box. Most outlet boxes commonly used for
the support of lighting fixtures are not acceptable for fan support and may
need to be replaced. Consult a qualified electrician if in doubt.
Step 7
Support Beam
"J" Hook (S9)
Outlet Box (A)
OUTLET BOX
Ceiling
Mounting Bracket (#1)
"J" Hook (S9)
Zip Tie (S10)
Safety Cable
Publicité
