Signs, Symbols And Abbreviations; Function; For Your Safety - WIKA LS-10 Mode D'emploi

3. Signs, symbols and abbreviations / 4. Function

3. Signs, symbols and abbreviations

Potential danger of life or of
!
severe injuries.
Warning
The product complies with
the applicable European
directives.
2-wire Two connection lines are intended for the voltage supply.
The supply current is the measurement signal.
3-wire Two connection lines are intended for the voltage supply.
One connection line is intended for the measurement signal.
4-wire Two connection lines are intended for the voltage supply.
Two connection lines are intended for the measurement signal.

4. Function

LS-10: Submersible pressure transmitter for level measurement, standard version.
LH-11: Submersible pressure transmitter for level measurement, High Performance.
Function: The hydrostatic pressure prevailing within the application is transformed into a stan-
dardised electrical signal through the deflection of the diaphragm, which acts on the sensor
element with the power supply fed to the transmitter. This electric signal changes in proportion
to the hydrostatic pressure and can be evaluated correspondingly.
4 WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio LS/LH-10
GB

5. For your safety

5. For your safety
Notice, important informa-
tion, malfunction.
CSA
Canadian Standard Asso-
ciation
The product was tested and
certified by CSA Internati-
onal. It complies with the
„
applicable Canadien stan-
„
dards on safety.
Certificate-No.: 1360840.
„
„
„
„
„
„
„
Information about material consistency against corrosion and diffusion can be found in our
WIKA-Handbook, 'Pressure and Temperature Measurement'.
WIKA Operating instructions/Betriebsanleitung/Mode d'emploi/Instrucciones de servicio LS/LH-10
Select the appropriate pressure transmitter with regard to scale range,
„
!
performance and specific measurement conditions prior to installing and
starting the instrument.
Warning
Observe the relevant national regulations (e.g.: EN 50178) and observe the
„
applicable standards and directives for special applications (e.g. with
dangerous media such as acetylene, flammable gases or liquids and toxic
gases or liquids and with refrigeration plants or compressors). If you do not
observe the appropriate regulations, serious injuries and/or damage
can occur!
Open pressure connections only after the system is without pressure!
Please make sure that the pressure transmitter is only used within the overload threshold
limit all the time!
Observe the ambient and working conditions outlined in section 7 „Technical data".
Ensure that the pressure transmitter is only operated in accordance with the provisions i.e.
as described in the following instructions.
Do not interfere with or change the pressure transmitter in any other way than described in
these operating instructions.
Remove the pressure transmitter from service and mark it to prevent it from being used
again accidentally, if it becomes damaged or unsafe for operation
Take precautions with regard to remaining media in removed pressure transmitter.
Remaining media in the pressure port may be hazardous or toxic!
Have repairs performed by the manufacturer only.
Open circuit before removing connector / cover.
GB
5