Publicité
Les langues disponibles
Les langues disponibles
power light (some Models): The light will be
illuminated when the power is on.
Fan power/speed Control: Turns the humidifier
'on' and 'oFF' . The power should always be off
before unplugging the humidifier, moving the
humidifier, or refilling the water tank.
niteGlo™ night light Control (some Models):
Turns the night light 'on' and 'oFF' . The night
light can be turned on even if the humidifier fan
is turned off.
1. remove The Care Free
rative Humidifier from its packaging. read
and save the instructions.
2. place the humidifier on a hard, flat, water
resistant surface. always place the humidifier
at least six (6) inches away from walls and
sources of heat.
3. lift the main housing to confirm that the
permaWick™ filters are placed upright in the
slots. replace the main housing. (see Figure
1.)
4. remove the water tank and take it to the sink
or tub to fill.
5. Turn the tank upside down and unscrew the
tank cap by turning it counterclockwise. Fill
the water tank with cool water and replace
the tank cap (never use hot water). Be sure
not to overfill the tank as water damage may
occur to furniture or flooring due to spill-
age.
HunTEr Will noT aCCEpT rEsponsiBiliTY
For daMaGE To propErTY CausEd BY
WaTEr spillaGE.
41553-01 01/03/2008
All manuals and user guides at all-guides.com
Humidifier Features
using Your Humidifier
Humidifier plus Evapo-
®
power light or niteGlo™
night light Control
power/speed
Control
Figure 2
6. Carry the tank back to the humidifier. Turn
the tank upright and place it on the humidi-
fier. Be sure that the tank is seated properly
in the base. if the tank is properly located on
the base, you will see air bubbles flowing up
into the tank.
7. With the power control knob in the 'oFF' posi-
tion, plug the humidifier into the wall.
CauTion: never plug in the Humidifier while
your hands are wet as Electric shock could
occur.
place the full tank on the unit and allow the
water to fill the bottom tray. The water is at
the proper level in the bottom tray when the
tanks stops bubbling. run the unit on "Hi"
speed for 1
⁄
minutes for optimum pump
1
2
operation. set the unit to the desired speed.
8. use the power control knob to turn the hu-
midifier 'on' by selecting a speed setting.
only for models with a niteGlo™ night light
9. use the control to turn the night light off and
on. The night light can be operated even if the
humidifier fan is turned 'oFF' .
4
© 2008 Hunter Fan Company
Publicité
