NOTES:
Do not load silver or silver-plated silverware with stainless
steel. These metals can be damaged by contact with each
other during washing.
Some foods (such as salt, vinegar, milk products, fruit juices,
etc.) can pit or corrode silverware. Run a rinse cycle if you do
not have a full load to wash immediately.
DISHWASHER USE
Detergent Dispenser
The detergent dispenser has 2 sections. The smaller Pre-Wash
section empties detergent into the dishwasher when you close
the door.
1
2
1. Cover latch
2. Main Wash section
3. Pre-Wash section
4. Cover
The larger Main Wash section automatically empties detergent
into the dishwasher during the wash. (See the "Cycle Selection
Chart.")
Use automatic dishwashing detergent only. Other detergents
can produce excessive suds that can overflow out of the
dishwasher and reduce washing performance.
Add detergent just before starting a cycle.
Store tightly closed detergent in a cool, dry place. Fresh
automatic dishwasher detergent results in better cleaning.
NOTE: Do not use detergent with a rinse cycle.
Filling the dispenser
1. If the dispenser cover is closed, open the cover by pushing
the cover latch.
2. Fill the Main Wash section with detergent. See "How Much
Detergent to Use."
3. Fill the Pre-Wash section, if needed.
4. Close the dispenser cover.
10
All manuals and user guides at all-guides.com
3
4
It is normal for the cover to open partially when dispensing
detergent.
NOTE: Use both sections for cycles with 2 washes. Use only the
main wash section for cycles with 1 wash. See the "Cycle
Selection Chart" for more details.
How much detergent to use
The amount of detergent to use depends on the hardness of
your water and the type of detergent. If you use too little,
dishes won't be clean. If you use too much in soft water,
glassware will etch.
Water hardness can change over a period of time. Find out
your water's hardness by asking your local water department,
water softener company, or county extension agent.
You can order a water hardness test strip. In the U.S.A., call
the Customer Interaction Center at 1-800-422-1230 and ask
for Part Number 4171690.
Different brands of dishwasher detergent have different
amounts of phosphorus for softening water. If you have hard
water and use a detergent with a phosphorous content of less
than 8.7%, you might need to use more detergent, or use a
detergent with a phosphorous content higher than 8.7%.
Water Hardness
Amount of Detergent
Soft to Medium
For normally soiled loads
Hard Water
0 to 6 grains per
gallon
NOTE: Add only 2 tsp or 10 g of
detergent to the Pre-Wash section if
dishes are pre-rinsed or the water is
very soft (0 to 2 grains per gallon).
For heavily soiled loads
Medium to Hard
For normal and heavily
Water
soiled loads
7 to 12 grains per
gallon
Very Hard Water
For normally and
heavily soiled loads
13 grains per gallon
and above
NOTE: It might be
necessary to use the
Baked on Cookware
cycle, or a normal
cycle with Hi-Temp
Scrub, for best wash
performance with
very hard water.
NOTE: Fill amounts shown are for standard powdered detergent.
Amounts may vary if you use liquid or concentrated powdered
detergent. Follow instructions on the package when using liquid
dishwasher detergent or concentrated powdered detergent.
Partially fill the Main Wash
section (5 tsp or 25 g)
Fill the Pre-Wash section
(4 tsp or 20 g)
Partially fill the Main Wash
section (7 tsp or 35 g)
Fill the Pre-Wash section
(4 tsp or 20 g)
Partially fill the Main Wash
section (7 tsp or 35 g)
Fill the Pre-Wash section
(4 tsp or 20 g)
Fill the Main Wash section
(8 tsp or 40 g)
Fill the Pre-Wash section
(4 tsp or 20 g)
Turn the rinse aid dispenser to a
higher setting. See "Rinse Aid
Dispenser" later in this section.