NUK VAPO RAPID Manuel D'instructions page 23

All manuals and user guides at all-guides.com
Vaporisator 09/08 Seite 19 Dienstag, 7. Oktober 2008 8:17 08
7. Faults and their rectification
Fault
Disinfection takes too long
The device does not switch on,
Control light 8 does not light up
The device does not switch on
8
again after use, control light
lit up
6 FIRST CHOICE bottles do not
fit into the device
Bottles are very hot after disin-
fecting
Bottles and accessories show
white marks after disinfecting
Steam is flowing out of the
accessory holder
European Model, with 2-PIN plug
(Article No. 10.251.012):
Voltage:
Power consumption:
Cause
Too much water in receptacle Measure exactly 70 ml for optimum
Base is heavily scaled
No power supply
Overheat protection is active Wait 15 minutes for the device to cool down.
is
Components not placed in
correctly
Bottles are disinfected at
above 90 °C
Device has limescale deposits Descale device (see "6.2 Descaling" on
Device has not been assem-
bled correctly
Bottles and accessories are
not suitably positioned in
holder
8. Technical data
British Model, with 3-PIN plug
(Article N. 10.749.054):
Voltage:
220 - 240 V~/50 Hz
Power consumption:
550 Watt
19
Rectification measures
disinfection
Descale base (see "6.2 Descaling" on
page 18)
Push plug in correctly
Check with other equipment as to whether
the socket has power supply
Place bottles upside down in the bottle
holder and without accessories.
Stack lids in bottle holder and then place the
basket on top
Allow bottles to cool down
Use the tongs supplied
page 18)
Assemble device correctly (see
"5.2 Disinfection" on page 17)
Separate the components so that the device
seals completely (see "5.2 Disinfection" on
page 17)
220 - 240 V~/50 Hz
550 Watt