Mestra 100210 Mode D'emploi page 7

The Ref. 100210 distiller/decalcifier is a simple and practical appliance: you will obtain 4
litres of distilled water by just filling the tank with tap water and waiting for about 6 hours. Its
operation is fully automatic and silent. Cleaning the tank is easy and quick. The water
produced is very pure (between 2 and 10 mg/litre of solid residue) and can be used in a
large number of applications in the clinic and the dental lab (autoclaves, compound making,
steam generating machines, etc.).
IMPORTANT- The appliance produces water of the "DISTILLED" type. It cannot be
used in injections, vials, and wound cleaning or in any other surgical operation that
requires "TRI-DISTILLED" type water.
SAFETY
- Read these instructions carefully before operating the unit.
- Keep these instructions for further consultation.
- Install the distiller on a dry, stable, heat-resistant and well-ventilated surface.
- The distiller requires a well-ventilated room. Bear in mind that while operating it
emits heat.
- Use the unit exclusively for the aim it was designed.
- Do not allow children or non-qualified personnel handling the unit.
- Keep the citric acid container out of children's reach.
- Disconnect the unit from the power source for maintenance operations.
- Unplug the distiller for cleaning or refilling it.
- Do not dip any element of the distiller.
- If you need to interrupt the distillation cycle, stop the distiller by unplugging it.
- Do not open the distiller while it is working.
- Wait at least 20 minutes after a distillation cycle to open the distiller for cleaning
it.
- Do not fill the tank with boiling water.
- WARNING: to prevent electric shock hazards, connect the unit to a proper
power source (grounded 230 V, 50/60 Hz).
- Do not use cord extensions or connect any other appliance into the same outlet.
- Do not use the unit in damp rooms or near inflammable materials (alcohol,
solvents...)
UNSUITABLE WATER FOR SURGICAL USE!
EN
English