Publicité
Les langues disponibles
Les langues disponibles
DO7245S
PARTS
5
1. Floor brush
2. Tubes
6
8
3. Flexible hose
4
4. On/off switch
2
5. Button lock/release dust cup
9
6. Dust cup
3
7. Base body
8. Hepa-filter
9. Air exhaust filter
1
7
ASSEMBLING THE VACUUM CLEANER
1. Fitting or removing the flexible hose
Insert the flexible hose into the air inlet on the top of appliance. Press until it clicks
into position.
Removing the flexible hose: remove the plug from the power socket and push on the
release button to remove the flexible hose from the air inlet.
2. Attach the telescopic tubes to the handle.
3. Attach the floor brush to the telescopic tubes.
ACCESSORIES
a) Crevice tool: for radiators, crevices, corners, baseboards and between cushions.
b) Dusting brush: used for furniture, blinds, books, lamp shades and shelves.
c) Small brush: used to clean the sofa.
INSTRUCTIONS FOR USE
1. Before using the appliance, unwind a sufficient length of cable and insert the plug
into the power socket. A yellow mark on the power cable shows the ideal cable length.
Don't pull the cable beyond the red mark.
2. Press the 'on/off ' button to switch the appliance on.
3. To rewind the power cable, press the rewind button with one hand and guide the
cable with the other hand to ensure that it does not whip causing damage.
MAINTENANCE
Spilling rubbish from the dust compartment subassembly.
Always operate the vacuum cleaner with the dust compartment subassembly installed.
Make sure to place the filter and Hepa-filter in the correct position.
1. Remove the flexible tube, press the lock/release button and remove the dust cup.
2. Press the bottom release button and empty the dust cup.
3. Replace the dust cup until it is locked.
Publicité
