ASROCK Fatal1ty Z170 Gaming K4 Serie Mode D'emploi page 24

2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over
these headers and connectors. Placing jumper caps over the headers and connectors
will cause permanent damage to the motherboard.
System Panel Header
(9-pin PANEL1)
(see p.1, No. 15)
PWRBTN (Power Switch):
Connect to the power switch on the chassis front panel. You may conigure the way to
turn of your system using the power switch.
RESET (Reset Switch):
Connect to the reset switch on the chassis front panel. Press the reset switch to restart
the computer if the computer freezes and fails to perform a normal restart.
PLED (System Power LED):
Connect to the power status indicator on the chassis front panel. he LED is on when
the system is operating. he LED keeps blinking when the system is in S1/S3 sleep
state. he LED is of when the system is in S4 sleep state or powered of (S5).
HDLED (Hard Drive Activity LED):
Connect to the hard drive activity LED on the chassis front panel. he LED is on
when the hard drive is reading or writing data.
he front panel design may difer by chassis. A front panel module mainly consists
of power switch, reset switch, power LED, hard drive activity LED, speaker and etc.
When connecting your chassis front panel module to this header, make sure the wire
assignments and the pin assignments are matched correctly.
Power LED and Speaker
Header
(7-pin SPK_PLED1)
(see p.1, No. 17)
20
All manuals and user guides at all-guides.com
PLED+
PLED-
PWRBTN#
GND
1
GND
RESET#
GND
HDLED-
HDLED+
SPEAKER
DUMMY
DUMMY
+5V
1
PLED+
PLED+
PLED-
Connect the power
switch, reset switch and
system status indicator on
the chassis to this header
according to the pin
assignments below. Note
the positive and negative
pins before connecting
the cables.
Please connect the
chassis power LED and
the chassis speaker to this
header.