Bissell ProHeat 2X 8920 Serie Mode D'emploi page 10

Carpet Cleaning (Continued)
Fill the Formula Tank. Fill up the Formula Tank
2.
by first unscrewing the Cap and Insert. Always
use genuine BISSELL formulas to maximize
cleaning and for the safety of your machine. Fill
formula up to the line and replace the Cap and
Insert. Place Formula Tank into the slot in the
back of the machine for a snug fit.
Set Custom Clean Dial. Simply choose one of
3.
the 4 settings (Heavy Traffic, Normal Clean, Light
Clean, or Rinse) and the ProHeat 2X will adjust
the right amount of cleaning solution
to mix with the heated water to fit your
cleaning need.
When your cleaning job is finished, the formula
can be stored ready to use in your machine for
the next time!
This feature is available on all ProHeat 2X
models, either at the foot of the machine,
or on the handle.
Set Ready Tools Dial to the Floor Cleaning
4.
Setting.
Turn the Power Switch and Heater On. Plug
5.
into a proper outlet and turn the Power and
Heater switches to the ON
minute for the built-in heater to warm-up before
cleaning. The ProHeat 2X will be fully warmed
and will provide optimal performance after a
minute of continuous heated cleaning.
Cleaning Strokes. While pressing the Trigger,
6.
make one slow forward wet pass and another
one back. Let the Built-In Heater, formula, and
DirtLifter PowerBrushes do the work for you.
Caution: Do not overwet. Take care not to run
over loose objects or edges of area rugs. Stalling
brush may result in premature belt failure.
Release the Trigger and make one slow forward
and backward pass over the same area to
remove any residual dirty water and aid in
drying. Repeat cleaning passes until solution
being pulled up appears clean. Continue passes
without pressing the trigger until you can't see
any more water being pulled up. After cleaning,
you may want to turn the Custom Clean dial
to Rinse to give your carpeting a final Water
Only rinse. This will ensure thorough removal of
embedded dirt loosened by the deep
cleaning formula. BISSELL deep cleaning
formulas contain an anti-resoiling agent that
helps your carpets repel dirt and keeps them
10 16 looking good longer.
( I )
position. Allow 1
Note: Your machine is equipped with a
circuit breaker that will automatically shut
off the brush if a large or loose object is
caught in the brush roll. If that happens, be
sure to unplug your machine, remove the
foreign object, and then plug the machine
back in to reset the circuit breaker. This can
also be done by turning the machine off and
back on once the object is removed.
WARNING:
To Reduce the Risk of Fire and
Electric Shock due to internal
component damage, use only
BISSELL cleaning fluids intended
for use with the deep cleaner.
Keep plenty of genuine BISSELL Fiber Cleansing
Formula and Scotchgard protector cartridges
TM TM
on hand so you can clean and protect whenever it
fits your schedule. Always use genuine BISSELL
deep cleaning formulas. Non-BISSELL cleaning
solutions may harm the machine and void
the warranty.
2 2a
3 3a
4 5
Power
Switch
Heater
Switch