Using the Microphone in function
When the unit is in Aux in mode or in Bluetooth mode, you can sing the songs by connecting
the microphones.
1. You can insert the microphone cable into the microphone in jack on the top of speaker,
press the STANDBY/MODE button to turn the unit on, then press STANDBY/MODE button
repeatedly on the unit or press the Mode button on the remote control to choose your
desired mode.
2. Tune the Microphone volume control knob to adjust the volume level of Microphone as
desired.
Turn the"-MIC VOL+" and "-ECHO+" to adjust the reverberation eff ect of Microphone sound /
speaker sound as your desired level.
Notes: The Microphone in jack can be compatible for Guitar. When you use the Guitar in
Microphone jack, its volume is controlled by "-MIC VOL+" and
"-ECHO+" accordingly.
Care of the appliance
Disconnect the appliance from the power source when cleaning.
If the unit becomes dusty, wipe it with a soft and dry duster. Use a soft cloth to clean this
appliance. Do not use any wax, polish sprays, or abrasive cleaners on the unit.
Caution
Never allow any water or other liquids to get inside the unit while cleaning. Dispose of
used batteries in an environmental-responsible manner. This product is not intended for
commercial use. Household use only.
Trouble Shooting
Before taking the unit to be repaired, please check the following table when a problem
occurs. Consult your dealer or service center if the problem cannot be solved with the
following information.
Problem
Power
System does not turn on
or does not respond to
the remote control.
Remote control
No functions or short
range.
Pairing the product
Cannot pair successfully
All manuals and user guides at all-guides.com
Remedy
- Make sure AC/DC power plug is connected to the wall socket
outlet properly and it has power.
- If this does not help, leave the unit unplugged before seeking
advice.
- Insert new batteries.
- Aim remote directly towards the remote sensor located in
center of speaker.
- Check whether the speaker is in Off or searching mode.
- Check whether there are other Bluetooth receivers around
your Bluetooth device. Turn them off to avoid any disturbance.
Attempt to pair again.
- You can click "Forget this device" and then re-pair it again
if required. Search for "DAEWOO DSK-300" on the Bluetooth
device and pair it again.