Black & Decker KW850E Mode D'emploi page 11

Using an extension cable
Always use an approved extension cable suitable
for the power input of this tool (see technical
data). Before use, inspect the extension cable for
signs of damage, wear and ageing. Replace the
extension cable if damaged or defective.
When using a cable reel, always unwind the cable
completely. Use of an extension cable not suitable
for the power input of the tool or which is damaged
or defective may result in a risk of fire and electric
shock.
PACKAGE CONTENTS
The package contains:
1 Router
3 Collets
1 Spanner
1 Edge guide
1 Dust extraction adaptor
1 Centring pin
1 Copy follower
1 Distance plate
1 Template guide
1 Instruction manual
Carefully unpack all parts.
OVERVIEW (fig. A)
1. On/off switch
2. Lock-off button
3. Variable speed control knob
4. Plunge lock lever
5. Fixing screws for edge guide
6. Collet
7. Spindle lock button
8. Revolver depth stop
9. Depth stop bar
10. Locking screw
11. Depth of cut scale
12. Dust extraction adaptor
ASSEMBLY
Before attempting any of the following
operations, make sure that the tool is
switched off and unplugged and that the
spindle has stopped.
All manuals and user guides at all-guides.com
Fitting a router bit (fig. B)
Fitting the edge guide (fig. C)
The edge guide helps to guide the tool parallel to
an edge.
Fitting the dust extraction adaptor (fig. D)
The dust extraction adaptor allows you to connect
a vacuum cleaner to the tool.
Fitting the template guide (fig. M & D)
Fitting the distance piece (fig. N)
Keep the spindle lock (7) depressed and rotate
the spindle until the spindle lock fully engages.
Loosen the collet nut (13) using the spanner
provided.
Insert the shank of the router bit (14) into the
collet (6). Make sure that the shank protrudes
at least 3 mm from the collet as shown.
Keep the spindle lock (7) depressed and
tighten the collet nut (13) using the spanner
provided.
Insert the bars (15) into the router base as shown.
Set the edge guide to the required distance.
Tighten the fixing screws (5).
Place the dust extraction adaptor (12) onto the
base of the tool as shown.
Insert the two screws (16) from the bottom
through the holes in the base and in the dust
extraction adaptor.
Place a nut (17) onto each of the screws and
securely tighten the nuts.
Fit the template guide (20) to the base of the
router, with the flange to the bottom
(= workpiece) side.
Insert the two long screws (16) from the
bottom side through the template guide and
the holes in the base.
Place the dust extraction adaptor on top of the
base as shown in fig. D.
Place a nut (17) onto each of the screws and
securely tighten the nuts.
Fit the distance piece (21) to the base of the
router using the screws provided.
E N G L I S H
11