LUND 67570 Mode D'emploi page 12

GB
housing. Do not carry the product by gripping the bowl's housing. Do not displace the product
by pulling the cable cord. Temperature at the place of installation and use of product must
stay within the temperature range of +10 C ÷ +38 C and the relative humidity must be less
O O
than 90%, without steam condensation.
Recommendations for connecting the product to power supply
Before connecting the product to power supply, make sure that the voltage, frequency, and
capacity of mains supply correspond to values shown on the product rating plate. Plug must fi t
into the socket. It is forbidden to modify the plug or socket in order to fi t each other.The product
must be connected directly to a single power outlet. It is forbidden to use extension cords,
socket-outlet adapters and double power outlets. Power supply circuit must be fi tted with a
protective conductor and at least 16 A protection circuit. Avoid any contact of power cord with
sharp edges and hot objects and surfaces. When operating the product, the power cord must
always be fully unwound and its position may not interfere with the operation of product. Laying
of power cable cannot result in tripping hazard. Power outlet should be located in such a place
to allow always for the possibility of quick disconnecting the plug of power cord supplying the
product. When disconnecting the plug of power cord, always pull the plug housing, never the
cable. If the power cord or plug is damaged, disconnect it immediately from the mains and
contact an authorized manufacturer's service centre for replacement. Do not use the product
with a damaged power cord or plug. The power cord or plug cannot be repaired, in case of a
damage to these components, replace them with new ones without defects.
Recommendations for using the product
WARNING! The bowl and the housing may be hot after use. Do not touch them as it poses
a risk of severe burns. Wait until the product components cool down. If it is necessary to
carry these elements before they cool down, grasp them only with handles intended for that
purpose. Use gloves that protect against the eff ects of high temperature. Make sure that the
fl oor next to the place where the product is used is not slippery. This will prevent the risk of
slipping, which may cause severe injuries.The product may be plugged in only during oper-
ation. After it is fi nished, unplug the product, by removing the plug from the mains socket.
Do not leave the connected product unattended. Food products placed in the bowl must not
protrude above the bowl's maximum fi ll. When preparing dishes, observe the product all the
time. Foodstuff s remained unattended may be burned, which may cause a fi re or severe
burns. The bowl should be carried only using the handle. The bowl has been fi tted with an
insert with perforated bottom designed for placing the food inside. Never use the bowl without
an insert. The insert is mounted in the bowl by means of a latch hidden under the movable
housing. When carrying the bowl, always cover the latch with a housing. This will prevent ac-
cidental separation of the bowl from the insert. The latch may be released only when the bowl
is placed on the ground. Put the bowl with hot food only on the grand that withstands high
temperature, or use protective stands. While preparing the inside of the chamber and dishes
themselves, you may touch them only with the use of tools made of such materials that will
withstand the temperature produced by the product. It is forbidden to use for this purpose
your bare hands. Do not use sharp, metal objects that may damage unstickable surface of
the bowl and insert. If any food waste remains during or after preparation of a dish inside the
bowl or insert, it should be removed before preparing next dish. Food waste may be burnt,
O R I G I N A L I N S T R U C T I O N S
12