S&P METEOR NT Mode D'emploi page 9

Slant adjustment
METEOR NT has 5 possible base slant grades to project the air in different directions,
both when the device is on a horizontal surface and when it is fitted to a wall or ceiling
(fig. 4). In order to modify the slant, simply support the base and push the fan backwards,
until you hear a click. You will usually find some resistance.
Note: The maximum slant can only be selected for wall or ceiling fitted devices.
MAINTENANCE
• Disconnect the appliance from the mains before cleaning.
• These devices require no special maintenance. Do not try to dismantle the appliance;
it will be sufficient to wipe the outside with a damp cloth and a little mild detergent. Do
not use solvents or abrasive products for cleaning.
• To clean the dust in the inlet and outlet grilles, as well as the fan blades, you can use
blown air or a vacuum cleaner.
• If you are not going to use the device for a long period of time, after cleaning it as men-
tioned above, store it in its original packing in a dry and dust-free location.
TECHNICAL ASSISTANCE
S&P's large Technical Service network will guarantee adequate technical assistance.
If a fault is observed in the unit, please contact any of the mentioned technical service
offices and they will attend to your problem.
Any manipulation of the appliance by personnel not belonging to the Official S&P Servi-
ces will result in your guarantee being void.
For any queries regarding S&P products please contact any branch of our After Sales
Service network if you are in Spain, or your regular dealer in the rest of the world. To find
your nearest dealer, visit our website at www.solerpalau.com
END OF SERVICE LIFE AND RECYCLING
Our commitment to future generations oblige us to recycle materials; please
remember to dispose of all unwanted packaging materials at the appropriate
recycling points, and to place obsolete equipment at the nearest waste mana-
gement point.
THE MANUFACTURER WILL NOT BE HELD LIABLE FOR DAMAGE TO PERSONS AND/
OR PROPERTY RESULTING FROM FAILURE TO COMPLY WITH THESE INSTRUCTIONS.
EN
9