Grammer PRIMO M Mode D'emploi page 20

Safety instructions
The driver's seat is
Any conversion or refitting work on a
exclusively in
adherence with the applicable operating, maintenance and installation instructions and in
compliance with all relevant national regulations.
and the proper function of the driver's seat or mounted parts can no longer be
guaranteed.
The driver's seat is
and the fixation must be checked from time to time.
you must check if all seat settings selected guarantee a
of the vehicle.
C onnecting d ata
If you need to connect cables to the vehicle supply network, strictly observe the following
instructions:
heater or the seat ventilation), you must obtain the relevant electrical data for the
respective vehicle with reference to voltage, protection and the kind of connections from
the manufacturer, from
For safety reasons, the installation and connection to the vehicle supply network must be
carried out by authorized specialist personnel only.
The seat connections must be protected independently of other vehicle components.
Seat heater
12V DC 10A
24V DC 7,5A
48V DC 5A
purely resistive load.
In case of inductive or capacitive load, the manufacturer must install a protective circuit
breaker for the consumers in the vehicle. If there are any uncertainties,
For building an electric connection, select an electric circuit by means of which the electric
consumers of the driver's seat are separated from the live network when
.
G uarantee and l iab il ity
AG does not disclaim any guarantee or liability for damage resulting from
incorrect assembly, use or repair of the seats.
Further details on the guarantee granted by
documents (see invoice or delivery note). Guarantee claims against
beyond the guarantee obligations described there are excluded.
20
All manuals and user guides at all-guides.com
and must be protected against splashes of water!
by
bear the risk of
. Worn parts such as rollers, shock absorbers
an
AG or the company's agencies.
Seat switch – Current carrying capacity
12V DC
Minimum and maximum current carrying capacity for
AG driver's seat must be performed
or
or
fitted in the driver's seat (e. g. the seat
10mA (min.)
.
AG are stated in your contractual
and in
AG
GB