All manuals and user guides at all-guides.com
original
AG parts) may impair the safety standard to which it has been tested.
must be approved by
During the removal and installation of the driver's seat, the corresponding instructions by
the specific vehicle manufacturer must be strictly observed!
Do not hold onto the covers for lifting the driver' s seats. If you do so anyway, there is an
Before you remove the driver's seat, disconnect all plug-in connections between the seat
and the vehicle supply network. When you replace the plug-in connectors, make sure they
are tight (dust, water).
Seatbelts are fitted or can be retrofitted to the driver's seat. Seatbelts
mounting area.
Seatbelts must be fitted in accordance with specific national regulations and guidelines,
and must be approved by
Seatbelts must be fastened
Where seatbelts are fitted to the driver' s seat, the
checked
Fasteners must be
loose bolts or other faults.
If you notice that the seat does not function correctly (for example a defective suspension
of the driver' s seat; improper curvature of the lumbar support or damaged bellows),
If you fail to do so, your health may be affected and the
Before the vehicle is used, switches that might be in the seat (for shutting down
mechanical equipment when the driver leaves his/her seat) must be checked for
.
If malfunctions are detected, the vehicle must not be driven.
–
weight during normal use, as the vehicle may otherwise start to move by itself.
–
If you take off the weight from the seat while driving, this will cause the vehicle to stop.
Do not indent the bellows while there is load on the driver's seat.
–
Make sure that the
.
GB
, threatening your
AG.
.
after an accident.
by specialist personnel after an accident has occurred.
–
–
–
Safety instructions
(for example fitting parts which are not
. For this reason,
AG.
.
, as they increase the load in the seat
and
. If the seat wobbles, there may be
to arrange for repairs to be carried out.
, except for the driver's
remains free of
must be
.
or
19