Publicité
Les langues disponibles
Les langues disponibles
MAIN BROOM
The main broom has been preset at the factory for maximum
sweeping efficiency. If adjustments are required for surfaces or
wear, this can be done by turning the adjustment knob. The height
indicator will show the position of the broom as you make your
adjustment. For best operating performance, the bristles of the
broom should just touch the floor. NOTE: If the main broom is set
too low, the sweeper will be hard to push.
SIDE BROOM
The side broom should be lowered and used when sweeping
along curbs or walls; it may also be used when sweeping
open areas. The side broom height should be adjusted to have
approximately 1/3 of the bristles touching the floor. To make an
adjustment, turn the adjustment knob.
OPERATING PUSH SWEEPER
Push sweeper forward at normal walking speed; it does not operate when pulled backwards.
EMPTYING THE DIRT HOPPER
1. To empty the dirt hopper, lift up on the handle located on the
front of the hopper, and empty contents into a proper container.
2. Replace dirt hopper back on sweeper by placing front edge of
hopper on sweeper frame.
3. Apply downward pressure until the hopper is in its proper
position.
4. The dirt hopper should be emptied after each use, or as
required. A full dirt hopper will affect the sweeping efficiency
of the push sweeper.
1. After each use, check for materials which may have become wrapped around brushes or wheels, and
remove immediately.
2. Do not lubricate gears, clutch or other internal parts.
3. Inspect rubber dust seals periodically for wear or damage; replace as required.
4. Inspect the main broom periodically for wear; replace when the bristles are worn to a length of 1½ inches
or less. The main broom can be easily replaced by removing three screws from each half. The same
screws can then be used to attach the replacement broom.
5. Side broom should be inspected periodically for wear; replace when (with the adjustment in the down
position) less than 1/3 of the bristles come in contact with the surface. The side broom can be easily
replaced by removing the screws from the brush holder and reassembling the replacement brush, using
the same hardware.
PAGE 6
All manuals and user guides at all-guides.com
SET UP AND OPERATION
MAINTENANCE
Adjusting Main Broom
Side Broom Knob
Side
Broom
Arm
Adjusting Side Broom
Dirt
Hopper
Emptying Procedure
Sweeper
Sweeper
Frame
Publicité
