klover BF-01 Installation, Utilisation Et Entretien, Conseils Utiles page 84

Maintenance of the boiler body
The thermo stove is equipped with a special magnesium anode to protect the boiler body and copper heat exchangers from corrosion due to stray currents
in the system.This anode protects from galvanic corrosion.
The anode must be controlled at least once a year and replaced when its diameter measures less than 15mm.
In order to inspect the boiler body, after the thermo stove majolica has been removed the upper lid must be removed, which is fixed with three knobs.
To replace the anode, just loosen it and screw-in the new one paying attention that the latter does not come into contact with the copper heat exchangers.
C.A.T Maintenance.
Punctual and systematic maintenance is a fundamental component for correct functioning, excellent thermal performance and duration of the appliance
through time. Therefore, it is recommended that qualified staff check the thermo stove at least once a year at the beginning of the season.
It is advised to agree an annual contract for product maintenance with the Authorised After-Sales Centre (C.A.T.).
CIRCUIT BOARD PARAMETERS
THE PARAMETERS MEMORISED ON THE CIRCUIT BOARD ARE FUNDAMENTAL FOR THE CORRECT FUNCTIONING OF THE THERMO STOVE
THE PARAMETERS GIVEN BELOW ARE ALREADY MEMORISED IN THE THERMO STOVE INSPECTION PHASE DIRECTLY IN THE FACTORY.
THESE PARAMETERS ARE THE RESULT OF CAREFUL TESTS WITH VARIOUS TYPES OF PELLETS AND MUST NOT BE CHANGED WITHOUT
THE AUTHORISATION OF KLOVER srl, SO AS NOT TO JEOPARDISE THERMO STOVE FUNCTIONING.
ALL LIABILITY IS DECLINED FOR DAMAGE CAUSED BY INCORRECT INTRODUCTION OF THE PARAMETERS.
CIRCUIT BOARD PARAMETERS
THE PARAMETERS MEMORISED ON THE CIRCUIT BOARD ARE FUNDAMENTAL FOR THE CORRECT FUNCTIONING OF THE THERMO STOVE
THE PARAMETERS GIVEN BELOW ARE ALREADY MEMORISED IN THE THERMO STOVE INSPECTION PHASE DIRECTLY IN THE FACTORY.
THESE PARAMETERS ARE THE RESULT OF CAREFUL TESTS WITH VARIOUS TYPES OF PELLETS AND MUST NOT BE CHANGED WITHOUT
THE AUTHORISATION OF KLOVER srl, SO AS NOT TO JEOPARDISE THERMO STOVE FUNCTIONING.
ALL LIABILITY IS DECLINED FOR DAMAGE CAUSED BY INCORRECT INTRODUTION OF THE PARAMETERS.
PARAMETER
Pr45 ON time of the screw feed motor reducer in the pre-load phase
Stand-by time for passage to the "LOAD PELL" phase
Pr46
Pr47 Flue intake device speed in pre-load phase
Pr48 Wood fumes temperature in order to consider the wood side on
Pr49 Minimum temperature for circulation pump start-up
PARAMETER
Pr55 Time for pellet side switch-on if the conditions exist after wood side switch-off
All manuals and user guides at all-guides.com
MAGNESIUM ANODE
Pre-load and additional parameters
DESCRIPTION
Additional parameters
DESCRIPTION
24
VALUE
02"
02"
35
150
50
VALUE
01'