Publicité
Les langues disponibles
Les langues disponibles
OPERATION
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you should clean
your kettle before use by boiling a full kettle of water twice and then discarding the
water. Wipe the surface with a damp cloth
1.
To fill the kettle, remove it from the power base and
open the lid by pressing the lid release button, fill with
the desired amount of water, and then close the lid.
Alternatively, the kettle may be filled through the spout.
The water level should not exceed MAX marks or sit
below MIN level. Too little water will result in the kettle
switching off before the water has boiled.
NOTE
Do not fill the water over the maximum level, as
water may spill out of the spout when boiling.
Ensure that the lid is firmly in place before
plugging the power outlet.
2.
Position the kettle on the power base.
3.
Connect the plug into a power outlet. Turn on the
switch by pressing it down to "I" position, the indicator
will light up. Then start to boil the water, the kettle will
switch off automatically once the water has boiled.
You can shut off the power by lifting the switch to "O"
position at any moment during boiling water. If you want
to boil water again, only turn on the switch directly to
restart the kettle.
NOTE
Ensure that switch is free of obstructions and the
lid is firmly closed, the kettle will not turn off if the
switch is constrained or if the lid is opening.
14
Publicité
