Technical Data; English | 9 - Bosch GTA 6000 Notice Originale

OBJ_BUCH-1402-001.book Page 9 Tuesday, February 22, 2011 10:13 AM

Technical Data

Saw stand
Article number
Dimensions of base
frame
Height of saw stand
Max. carrying capacity
(power tool + work-
piece)
Weight, approx.
Assembly
Delivery Scope
Please also observe the represen-
tation of the delivery scope at the
beginning of the operating in-
structions.
Before assembling the saw stand, check if all
parts listed below are provided:
– Base frame 2
– Saw stand legs 3 (4 pcs.)
– Fastening kit 4 consisting of:
Phillips screws M8 x 45 (4 pcs.),
Lock nuts M8 (4 pcs.)
– Fastening kit 5 consisting of:
Hexagon bolts, M8 x 75 (4 pcs.),
Washers M8/18 mm (8 pcs.),
Nuts M8 (4 pcs.)
Additionally required tools (not in delivery
scope):
– Phillips screwdriver
– Open-end spanner (13 mm)
Bosch Power Tools
Assembling the Saw Stand
(see figures A1
GTA 6000
– Carefully remove all parts included in the de-
Professional
0 601 B24 100
– Remove all packaging material.
– Place the folded together base frame 2 flat
mm 670 x 750
– Pull the base frame 2 up by the release levers
mm 602
– Let go of the release levers 1 while pulling
kg 100
– Insert the saw stand legs 3 into the square
kg 12.5
– Screw the saw stand legs and the base frame
Fastening the Power Tool (see figure B)
– Centre the power tool on the base frame.
– Fasten the machine to the base frame 2 with
Operation
Working Advice
Do not overload the saw stand. Always observe
the maximum carrying capacity of the saw
stand.
Always hold the workpiece firmly, especially the
longer and more heavy section. After cutting
through the workpiece, the centre of gravity
may become dislocated in such an unfavourable
manner that the saw stand tips over.
Transport
The saw stand can be folded together for trans-
port.
– Remove the power tool.
– Pull the release levers 1 upward and fold the
A2)
–
livery from their packaging.
on the floor.
1.
up, so that the saw stand can engage.
tubing of base frame 2 so that the mounting
holes are aligned.
together with the screws and nuts of fasten-
ing kit 4.
fastening kit 5.
When folding the saw stand together or
apart, the power tool may not be mounted
to the saw stand.
saw stand together.
1 609 929 Y29 | (22.2.11)

English | 9