HumanTechnik soundshuttle Mode D'emploi page 7

We would like to congratulate you on purchasing your soundshuttle .
You have chosen a modern, reliable device. Please read through these opera-
ting instructions carefully. They tell you how to set up the system correctly and
explain all the system's features to you.
How it works
The soundshuttle uses its built-in microphone to record sounds and emits them
via the built-in induction loop. The signals emitted in this way can be received
by a hearing aid that is set to the "T" or "MT" position.
Package contents
The following parts are included in the package:
- soundshuttle
- Power supply unit
- Operating instructions
- Warranty card
Setting up the soundshuttle
The induction loop system is already completely installed and set up in the hou-
sing. All you have to do is to place the soundshuttle at the desired position bet-
ween you and the person you are talking to and connect the power supply unit.
Please note that the microphone on the back of the device should be facing the
speaker.
Switching the device on
To switch the induction loop system on, press the green button on the top of the
device. Once the device is switched on, the control lamp will light up green.
Recording/ emitting signals
If sounds are received by the microphone on the back of the device and emitted by
the device as magnetic signals, the control lamp will begin to flash orange.
Additional microphone input (3.5 mm plug)
An external microphone can be connected to the additional microphone input. (e.g.
microphone cable A-4901-0) (If an external microphone is used, the built-in micro-
phone will be switched off automatically.)
English 7