Standard Accessories; Applications - Hitachi M 8V2 Mode D'emploi

English
ROUTER SAFETY WARNINGS
1. Hold power tool by insulated gripping surfaces,
because the cutter may contact its own cord.
Cutting a "live" wire may make exposed metal parts of
the power tool "live" and shock the operator.
2. Use clamps or another practical way to secure and
support the workpiece to a stable platform.
Holding the work by your hand or against the body
leaves it unstable and may lead to loss of control.
3. Single-hand operation is unstable and dangerous.
Ensure that both handles are gripped fi rmly during
operation.
4. The bit is very hot immediately after operation. Avoid
bare hand contact with the bit for any reason.
DESCRIPTION OF NUMBERED ITEMS
(Fig. 1 – Fig. 17)
1 Lock pin
2 Wrench
3 Loosen
4 Tighten
5 Stopper pole
6 Scale
7 Depth indicator
8 Pole lock knob
9 Stopper block
0 Loosen the lock lever
! Nut
@ Threaded column
Cut depth setting
#
screw
$ Template guide
% Screw
^ Bit
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
M8V2: Router
Read all safety warnings and all instructions.
Always wear eye protection.
Always wear hearing protection.
Template
&
Straight guide
*
Guide plane
(
Bar holder
)
Feed screw
q
Guide bar
w
Wing bolt (A)
e
Wing bolt (B)
r
Dial
t
Separate
y
Router feed
u
Workpiece
i
Rotation of bit
o
Trimmer guide
p
Roller
a
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2002/96/
EC on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
Disconnect mains plug from electrical outlet
Class II tool

STANDARD ACCESSORIES

(1) Straight Guide .............................................................1
(2) Bar Holder ....................................................................1
Guide Bar .....................................................................2
Feed Screw ..................................................................1
Wing Bolt .....................................................................1
(3) Template Guide ...........................................................1
(4) Wrench ........................................................................1
(5) Wing Bolt (A) ................................................................4
(6) Lock Spring ..................................................................2
Standard accessories are subject to change without notice.

APPLICATIONS

○ Woodworking jobs
chamfering.
SPECIFICATIONS
Model
Voltage (by areas)*
Power Input*
Collet Chuck Capacity
No-load speed
Main Body Stroke
Weight (without cord and
standard accessories)
* Be sure to check the nameplate on product as it is subject
to change by areas.
NOTE
Due to HITACHI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms to the
power requirements specifi ed on the product nameplate.
2. Power switch
Ensure that the power switch is in the OFF position. If the
plug is connected to a receptacle while the power switch
is in the ON position, the power tool will start operating
immediately, which could cause a serious accident.
6
centered on grooving
M8V2
(110 V, 230 V)
1150 W
8 mm or 1/4"
11000 – 25000 min
60 mm
3.6 kg
and
-1