DeWalt DXPAEV040 Manuel D'instructions page 7

Wall Bracket Installation for Drywall or
Studs
REQUIRED TOOLS (NOT INCLUDED)
1. Level
2. Pencil
MOUNTING THE WALL BRACKET
1. Loosen the bolt at the bottom of the main unit to take the wall
bracket off, using the T25 torx L-key.
2. Use a stud finder to locate the center of a wall stud. Use a
level and a pencil to draw a vertical line down the center of
the wall stud.
3. Hold the wall bracket against the installation surface. Align the
vertical line to the holes of the wall bracket. Firmly mount the
wall bracket using the provided screws.
WARNING: At least two screws must be fastened through the
bracket into the stud� For the other holes, it is recommended that
other secure drywall fastening means be utilized�
3. Stud finder
4. Philips screwdriver/bit
Plug-in Installation
CAUTION: Ensure that the existing NEMA outlet corresponds with
the specification of the product� Alternatively, a licensed electrician
may install a NEMA 14-50 outlet�
CAUTION: The NEMA 14-50 outlet should be located 43-59 in
(110-150 cm) from the ground adjacent to the stud where the
product is to be mounted�
1. Hang the main unit from the top of the wall bracket.
2. Fasten the bolt at the bottom of the main unit using the T25
torx L-key (recommended torque 5.0 to 5.8 N·m).
3. Connect the power plug to the NEMA 14-50 outlet.
7
CABLE LENGTH
12" (30 cm)