Publicité
Les langues disponibles
Les langues disponibles
Parts:
Spout
Water
Level
Indicator
Plastic
Body
Using Your Kettle:
1. Open the lid then fill the water into the Kettle. CAUTION: Do not overfill the product or
operate it when empty.
2. Close the lid. Place the Kettle back onto the base unit. Making sure there is not water on
the bottom of the Kettle.
3. Turn the Kettle on by pushing the switch from "O" (off) to "I" (on).
4. The Kettle will automatically switch off to the "O" position once the water has boiled. The
indicator light will turn off. Note: the switch only works when the Kettle body is correctly
placed on base unit.
5. Lift the Kettle from the base using its handle and pour out your hot water into your
container. Note: if you need to heat water again, let the appliance rest for 30-60 seconds
before starting again.
6. When heating is complete, make sure the power switch is on the "O" position, and then
unplug the product from the electrical outlet. WARNING: Always unplug the product from
the electrical outlet when it is not in use or will be left unattended.
Cleaning Your Kettle:
WARNING: Always unplug the product and allow it to cool before cleaning or storing.
NOTICE: To avoid damaging the product, do not pour cold water into the Appliance after use
and do not use abrasive cleaners/pads to clean any part of the product.
• Make sure the Kettle is empty and has had time to cool before handling it.
• Do not run any part of this appliance in the Dishwasher.
• Remove Kettle from base and clean with non-abrasive cleaners and warm soapy water.
• Base should only be cleaned with a soft damp towel and dried before storing. DO NOT USE
RUNNING WATER.
• Dry all parts thoroughly before storing or using again.
Lid
4
Handle
Power
Switch
Power
Base
Publicité
