Olimpia splendid ARYAL S1 E INVERTER 18 C Mode D'emploi Et D'entretien page 89

4.4 - TROUBLESHOOTING
1. The unit may stop running or keep running safely if:
- the LEDs keep flashing
- on the display appears one of the following codes:
E(x), P(x), F(x), EH(xx), EL(xx), EC(xx), PH(xx), PL(xx), PC(xx)
Wait approximately 10 minutes; the problem may solve by itself.
If not, disconnect power supply and reconnect it. Switch on the unit.
If the problem persists, disconnect the unit from the power supply and contact the closest service centre.
2. Stop the air conditioner immediately is one of the following anomalies occurs.
Disconnect the electric power supply and contact the nearest after-sales assistance service.
Problem:
- The fuses blow frequently or the automatic switch intervenes often.
- Water or other objects have entered the air conditioner.
- The remote control does not function or functions anomalously.
4.4.1 - Malfunctioning
Do not try to repair the unit alone.
Malfunctioning
The unit will not start.
The unit does not cool or heat
the room well (only for cooling/
heating models), while air
escapes from the conditioner.
If the problem has not been solved, contact the local dealer or nearest after-sales assistance service. Provide
detailed information regarding malfunctioning and the unit model.
Cause
Current failure
The unit is disconnected from the
current.
A fuse has blown.
The remote control batteries may be
discharged.
The time set with the timer may not
be correct.
Incorrect temperature setting.
The air filter is clogged.
The doors or windows are open.
The air inlet or outlet vents of the
indoor or outdoor units are blocked.
The compressor 3 minute protection
has activated.
What must be done?
Wait for the current to be restored.
Check that the plug is inserted in the
wall socket.
Replace the fuse.
Replace the batteries.
Wait or annul the timer setting.
Set the temperature correctly. Consul
the "Using the remote control" chapter
for the procedure.
Clean the air filter.
Close the doors or windows.
First, remove the obstructions and
then re-start the unit.
Wait.
ARYAL S1 E INVERTER 18-24C
EN - 37