Agilent Technologies Turbo-V 2000 ICE Notice De Mode D'emploi page 249

N
1
Where:
XX = indicates the rotational speed (33 KRPM for high speed, or 26
KRPM for low speed).
Monitor Relay Programming
The display shows:
H
S
Where:
XXKRPM = is the switch point of relay S1 at the preset turbopump
speed, adjustable from 00 to 38 KRPM. The speed threshold will
condition the S1 operation (see the following cycle diagram] and it is
factory-set to 30 KRPM.
The speed threshold will condition the S2 operation (see the
following cycle diagram] and it is factory-set to 23 KRPM.
Pump Shutdown
Press the front panel STOP push-button or remove the remote signal;
the power from the turbopump will be removed and the pump will
begin to slow down.
Turbo-V 2000 ICE Controller User Manual / 87-900-929-01 (L)
After the run up time and when the normal rotational speed is
reached, the display will be as follows, even if any previous
display selection was made, and the normal condition has been
reached.
O R M A
2 X X
. S .
E T T I
L O P E
K R P M
T H R E S
N G ; X
Technical Information
Use
R A T I
H J
H O L D
X K R P M
249/260
17
O N
H S