Publicité
Les langues disponibles
Les langues disponibles
CONNECTING THE FEEDER
CONNECTING THE FEEDER CABLE
CABLE
To connect the feeder cable to the cooker
it is necessary to:
To connect the feeder cable to the cook-
er it is necessary to:
– Remove the two screws that hold shield
"A" behind the cooker.
– Remove the two screws that hold
shield A behind the cooker.
– Open completely the cable clamp "D".
– Open completely the cable clamp D.
– Position the U bolts onto terminal block
"B" (fig. 9.1) according to the diagram in
– Position the U bolts onto terminal block
figs. 9.2, 9.3.
B (fig. 10.1) according to the diagram
in fig. 10.2a, 10.2b, 10.2c.
– Insert the feeder cable into the cable
clamp "D". The supply cable must be of
– Insert the feeder cable into the cable
a suitable size (see the section "Feeder
clamp D. The supply cable must be
cable section").
of a suitable size (see the section
"Feeder cable section").
– Connect the phase and earth cables to
terminal "B" according figures 9.2, 9.3.
– Connect the phase and earth cables
to terminal B according figures 10.2a,
– Pull the feeder cable and block it with
10.2b, 10.2c.
the cable clamp "D".
– Pull the feeder cable and block it with
– Re-mount shield "A".
the cable clamp D.
N.B. The earth conductor must be left
– Re-mount shield A.
about 3 cm longer than the others.
N.B. The earth conductor must be left
about 3 cm longer than the others.
D
Fig. 9.1
204
FEEDER CABLE SECTION
"TYPE H05RR-F"
230 V ac
400 V 3N ac
400 V 2N ac
(**) Connection with wall box connection.
–
–
B
A
3 x 6 mm
5 x 2,5 mm
4 x 6 mm
Diversity factor applied.
A diversity factor may be applied to the
total loading of the appliance only by a
suitably qualified person.
(**)
2
(**)
2
(**)
2
Publicité
