Thermador MEMCW271ES Guide D'utilisation Et D'entretien page 8

Cleaning and Maintenance
Cleaning
Part
Drawer interior (polished
stainless steel)
Painted surfaces
Drawer exterior frame
(brushed stainless steel)
Warming Drawer Control
English 6
All manuals and user guides at all-guides.com
Recommendations
Use dish detergent.
Wash, rinse well and dry.
For hard water spots or
scale, use white vinegar.
Apply with a sponge or
cloth, rinse, and dry.
Heat Discoloration/
Corrosion: Clean with
Bar Keeper's Friend®
sprinkled on a wet
sponge or wet cloth and
applied to the wet
stainless steel surface.
Rub gently and evenly in
the direction of the grain.
Rinse and dry.
Use hot soapy water or
mild cleaners such as
Fantastik or Formula
409Wash, rinse well
and dry. Avoid using
abrasive cleaning
agents, steel wool pads
and oven cleaners.
Always wipe or rub in the
direction of the grain.
Clean with a soapy
sponge, then rinse and
dry, or wipe with
Fantastik® or Formula
409® sprayed on a
paper towel. Protect and
polish with Stainless
Steel Magic® and a soft
cloth. Remove water
spots with a cloth
dampened with white
vinegar.
Clean with hot soapy
water or apply
Fantastik® or Formula
409® to a clean sponge
or paper towel and wipe
clean. Avoid using
abrasive cleaners and
scrubbing pads.
Maintenance
Removing the Drawer
WARNING:
To prevent burns, do not remove drawer
while hot. Be sure drawer is empty before
removing.
1. Pull drawer to fully open position.
2. Press down right drawer clip.
3. Lift up left drawer clip.
4. Firmly pull the drawer straight out. Retract cabinet rails
while drawer is removed.
Replacing the Drawer
1. Be sure cabinet rails are pushed inside cabinet.
2. Align the drawer rails with the cabinet rails.
3. Firmly push the drawer straight into the cabinet until
drawer clicks into place.
4. Open and close drawer to test operation. Note: if the
drawer will not close, verify that the rail clips are
properly positioned.
Me d
Low
Pro of
Hig h
+
_
On /Of f