MSA GasGard XL Manuel D'utilisation page 17

4.2 Status Info Symbols
Alarm 1:
Displays if alarm level is reached
Alarm 2:
Displays if alarm level is reached
Overrange:
Displays if channel signal is above the range (more than 105 % of full scale).
Underrange:
Displays if channel signal is below the range (less than -5 % of full scale)
Sensor Fault:
Displays if a sensor connection is broken or shorted or if signal falls below -10% of full
scale
Internal Channel Fault:
Displays if Channel board has a system fault
In Service:
Displays if channel is in service mode (calibration)
Inhibit:
Displays if channel is inhibited
STEL Alarm:
Displays if STEL alarm is reached
TWA Alarm:
Displays if TWA alarm is reached
Battery included and fully charged
Battery not included
If FlameGard is connected to the mA Channel board, the basic screen contains additional symbols
for FlameGard status:
FlameGard Detector is connected – No Flame
Warning - FlameGard Detector is in the first alarm condition
Alarm - FlameGard Detector is in second alarm condition
• The channel where an alarm condition is reached first is identified by blinking value.
GasGard XL
Operation
US
17