Publicité
Les langues disponibles
Les langues disponibles
English
•
Always unplug the appliance after use and before installing or removing parts or
performing any maintenance and cleaning tasks. Also unplug it in the event of a power
cut. The appliance must be switched off when plugging it in or unplugging it.
•
Never pull on the cord or hang the appliance from it. Always unplug the appliance by
pulling on the plug, never on the cord.
Do not use the hair dryer near baths, washbasins, showers or other water
containers. If it falls into water, do NOT try to pick it up. Unplug it immediately.
Never submerge the appliance in water or any other liquids and do not put it in
the dishwasher. Do not allow the appliance to come into contact with water during
cleaning.
•
Avoid splashing the appliance or the power cord.
•
Never leave the appliance outdoors exposed to the elements.
•
Do not touch the appliance with wet hands when in operation.
•
Never leave the appliance working on a wet surface or cloth.
•
When using the hairdryer in the bathroom, unplug it after use, since it is dangerous for
the appliance to be near water, even when the hair dryer is switched off.
•
As additional protection we recommend the installation of a fault current protection
device (FI/RCD) with a rated current of not more than 30mA in the wiring system of the
bathroom. Please contact an authorised electrician for advice.
Product Description
A. Air inlet grill
C. Air flow control button
E. Air Concentrator
Overheat protection
This device has a thermostat that regulates the temperature to prevent it from
overheating (if the air inlet or outlet is blocked). If this happens, disconnect the
device and wait for five minutes. Remove the cause of the obstruction, and
switch the appliance back on.
Using the appliance
Be sure that the air inlet and outlet are not obstructed.
1. Plug the appliance into the mains and set the airflow regulator (C) to the desired
O
position:
- off,
2. Set the temperature selector (D) to the desired position:
II
heat,
- maximum heat.
B. Air outlet
D. Temperature selector
F. Diffuser
I
- minimum speed,
II
- maximum speed.
2
O
- minimum heat,
I
- medium
Publicité
