Publicité
Les langues disponibles
Les langues disponibles
1. P
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
REPARE INSTALLATION
2. S
ELECT INSTALLATION TYPE
3. W
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
IRING INSTALLATION
4. I
NSTALL HOOD MOUNTING BRACKET
5. I
NSTALL UPPER FLUE MOUNTING BRACKET
6. R
EMOVE GREASE FILTERS
7. I
6"
NSTALL
ROUND ADAPTER
8. I
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
NSTALL THE HOOD
1. PREPARE INSTALLATION
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the retailer.
Make sure that the following items are included:
- Hood
- Decorative flue assembly (lower and upper flues)
- Hood mounting bracket
- Lower flue mounting bracket
- Upper flue mounting bracket
- 2 Aluminum grease filters
- 6" Round adapter/damper
- Installation instructions
- Parts bag: 8 no. 8 x 5/16" mounting screws,
7 no. 8 x 1½" mounting screws,
7 drywall anchors, 2 washers
Parts sold separately:
- Ducts, elbows, wall and roof caps.
- Non-duct kit model RK56, mandatory for non-ducted installation.
NOTE: During installation, protect countertop and/or cooktop.
2. SELECT INSTALLATION TYPE
When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
2.1 N
-D
I
ON
UCTED
NSTALLATION
The RK56 non-duct kit is required for a non-ducted installation.
2.2 D
I
UCTED
NSTALLATION
Plan where and how the ductwork will be installed.
A straight, short duct run will allow the hood to perform most efficiently. Long duct
runs, elbows and transitions will reduce the performance of the hood. Use as few
of them as possible. Larger ducting may be required for longer duct runs.
Install wall or roof cap. Connect 6" round metal ductwork to cap and work back
towards the hood location. Use 2" metal foil duct tape to seal the joints.
2.3 A
I
LL
NSTALLATIONS
The minimum hood distance above cooktop is 26" (30" over a gas range).
A maximum of 30" above cooktop is recommended for best capture of cooking
impurities.
Distances over 30" are at the installer and users discretion providing that ceiling
height and decorative flue length allow it.
TABLE OF CONTENTS
. . . . . . . . . . . . . . . . . . . . . . . . . 3
. . . . . . . . . . . . . . . . . . . . 4
. . . . . . . . . . . . . . . . 5
. . . . . . . . . . . . . . . . . . . . . . . . . . 5
/
. . . . . . . . . . . . . . . . . . . 5
DAMPER
9. D
UCT CONNECTION
10. P
REPARE THE DECORATIVE FLUE
11. I
NSTALL THE DECORATIVE FLUE
12. R
EINSTALL GREASE FILTERS
13. O
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
PERATION
14. C
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
ARE
15. R
EPLACEMENT PARTS
16. W
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
ARRANTY
D
ECORATIVE
FLUE
U
PPER FLUE
MOUNTING BRACKET
HR0205A
WARNING
!
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
. . . . . . . . . . . . . . . . . . . . . . 7
. . . . . . . . . . . . . . . . . . . . . .7-8
. . . . . . . . . . . . . . . . . . . . . . . . . 8
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
R
OOF CAP
D
ECORATIVE
FLUE
H
OOD
26"
MINIMUM ABOVE
COOKING SURFACE
(30"
)
FOR GAS RANGE
HH0252A
6" R
OUND
/
ADAPTER
DAMPER
L
OWER FLUE
MOUNTING BRACKET
H
OOD
MOUNTING BRACKET
6" R
OUND
DUCT
W
ALL
CAP
6" R
OUND
ELBOW
Publicité
