sanindusa SAFIRA Notice De Montage page 6

INSTRUÇÕES DE MONTAGEM
90min
1X
1X
12X
Pre-Installation Checks
1. Check you have the correct product. Please look at the labels on the side of the product packaging.
2. Check all the product components are in the box and the fixing kits.
3. Unpack your product and handle it with care.
4. Please check the product for defects or damage, once the installation has commenced we cannot accept responsibility for any defects or
damage.
5. Please take time to read these instructions prior to installing your product.
6. Before you commence any drilling check there are no hidden electrical cables and/or water pipes.
7. No attempt should be made to re-work the toughened safety glass.
8. The installation of the product should be performed by two persons.
9. It is strongly recommended that the walls the product is going to be installed on are vertical.
10. It is strongly recommended the product is fitted on a tiled surface or similar waterproof surface.
11. It is strongly recommended the walls are tiled and grouted before the product is installed.
12. If the walls and/or the tray are not level you will not achieve maximum adjustment of the product.
13. Pictures used are for illustration purposes only, product designs may alter slightly as a result of continuing product development.
14. We do not stipulate where the European Standard Kite Mark should be positioned on the glass when being factory assembled.
15. Please note that some natural misting may occur when you remove this product from its packaging, due to the addition of the glass protec-
tion pre-coating. If this does occur this can easily be removed with a soft, dry cloth.
Be aware toughened glass can shatter if not handled correctly. It
should not be subjected to any sharp impact and it is essential to
protect the glass by resting it on a soft protective surface during
installation such as cardboard or carpeting. It is recommended to
wear PPE at all times during installation.
Sanindusa S.A. reserva o direito de fazer alterações técnicas sem aviso prévio.
Sanindusa S.A. reserva el derecho de hacer alteraciones técnicas sin previo aviso.
ASSEMBLY INSTRUCTIONS
6X 9mm
3X 40mm
3X
1X 2.5mm
12X
Step 1 - Pre-Installation Checks
1. Check the tray is level on all sides (the bubble on the spirit level must be in the centre of the 2 lines).
2. Stand in the tray and check that there is no adverse movement (correct if necessary).
3. The walls should be tiled and grouted up to the tray.
4. The tiles and the tray should be sealed using a good quality bathroom sealant.
• Spray the seal and joints with the shower head and check for leaks when the silicon has cured.
• Check the plumbing for leaks.
• DO NOT plasterboard over the tray.
• DO NOT grout the tiles when the enclosure has been fitted,
the grout may discolour the aluminium profiles.
• Make sure the tray is installed as per the manufacturer's
instructions.
Sanindusa S.A. reserves the right to introduce technical improvements without previous notice.
NOTICE DE MONTAGE INSTRUCCIONES DE MONTAJE
6mm
4.5mm
Description
Wall Profiles
Bifold Door Assembly
Door Handle Assembly
This product's warranty lasts for a period of 10 years from the date
of purchase. Sanindusa declines any and all responsibility after this
period. To solve any warranty issues, please contact the retailer
where you purchased the product.
Sanindusa S.A. si reserva il diritto di effettuarre cambiamenti tecnici sensa preaviso.
8963802211IM00 - 8963902211IM00 - 8963002211IM00
INSTRUZIONI DI MONTAGGIO
Component Check List: Supplied
Consumer Warranty
Sanindusa S.A. réserve le droit de faire des altérations techniques sans information prealable.
SAFIRA
Quantity
2
1
1
1