sanindusa SAFIRA Notice De Montage page 10

Problem
Leaking
Enclosure Alignment
on the Tray
Door not running Smoothly
Door Alignment
Some important information to help you Maintain your product.
The following information is all you need to keep your product looking new.
Clean your product using a mild detergent diluted in water and then polished off using a soft cloth.
If you live in a hard water area, periodically clean your product using a 50/50 solution of white vinegar and water. The solution should be left on
the enclosure for approximately 5 minutes then rinsed off using warm water. This method of cleaning should remove lime scale residue.
Simple Maintenance
Our products are generally maintenance free, however it may be necessary to lubricate wheel assemblies and other moving parts from time to
time.
It is strongly recommended that a quality silicone spray is used.
A list of Don't's:
1. Don't use acidic based products which are unsuitable for cleaning enamel surfaces.
2. Don't use abrasive cleaners or cleaners using bleach or solvents, these products will adversely affect the finish of the aluminium profiles.
3. Don't use scouring pads, powder or any sharp instruments when cleaning the enclosure.
Should you experience any problems during installation please refer to the
Trouble Shooting Guide or contact Customer Relations on: +(351) 234 940 250
Sanindusa S.A. reserva o direito de fazer alterações técnicas sem aviso prévio.
Sanindusa S.A. reserva el derecho de hacer alteraciones técnicas sin previo aviso.
Trouble Shooting Guide
Solution
1. Check that the inside gap between the Tray and Wall profiles has been sealed correctly.
2. Ensure the tray is sealed along the tiled walls prior to installation.
3. If the inside joint between the enclosure and the tray top is sealed, this will cause leakage -
sealant must be removed.
4. Ensure the wall profiles on the tiled walls are sealed both vertically inside and outside.
5. Ensure the joint between the enclosure and tray top is sealed.
IMPORTANT: This enclosure should be water tested conforming to BS EN 14428
1. Is the enclosure fitted onto a tiled wall?
2. Is the wall profiles fitted 10mm from outside of the tray?
3. Are the wall profiles completely vertical?
1. Ensure both wall profiles are completely vertical.
2. Ensure the tray is completely level.
3. The Bearing Moulding may need moving to let the bearing run better.
1. Ensure both wall profiles are completely vertical.
2. Ensure the tray is completely level.
3. Check both Wall Profiles are in line with each other.
Sanindusa S.A. reserves the right to introduce technical improvements without previous notice. Sanindusa S.A. réserve le droit de faire des altérations techniques sans information prealable.
Sanindusa S.A. si reserva il diritto di effettuarre cambiamenti tecnici sensa preaviso.