Step 7: Backguard Installation; Wire Connection - Thermador An American Icon Professional PRO-GRAND PRD30 Manuel D'installation

4-Wire Connection

1. Remove upper nuts only from the terminal block studs.
Do not remove lower nuts which secure range
internal wiring leads.
2. Remove ground strap screw and bend the strap up as
shown in Figure 12.
3. Secure the neutral wire to the center stud of the
terminal block with nut.
4. Secure the L1 (black) and L2 (red) power leads to the
outside terminal studs (brass colored) with nuts.
5. Secure the bare copper ground lead to the range
chassis using the ground screw previously used for the
ground strap. Be sure that neutral and ground
terminals do not touch.
6. Tighten all connections securely.
Bend Ground Strap Up
L1 Black
English 16
Figure 12: Ground Strap
L2 Red
Neutral Wire
Ground Wire
Figure 13: Secure Neutral Wire

Step 7: Backguard Installation

The backguard must be attached before sliding the range
into the final installed position. A Low Back or Pot-and-Pan
Shelf must be installed when there is less than a 12"
clearance between a combustible back wall and the back of
the range above the cooking surface. (See Figure 2 on
page 6).
An Island Trim is available for covering the backguard area
of the range for island installations; however, the Island
Trim can only be used where there is a minimum of 12"
horizontal clearance between a combustible back wall and
the back of the range. (See Figure 2 on page 6).
Align the back panel of accessory with the flange on the
range side panel right and left rear corners. The backguard
is inserted inside the guide channels on the back of the
range. (See Figure 14.)
Make sure the backguard's front face is outside of the
flange at the back of the range.
Install screws through the backguard's front face panel into
the flange on the range. The 30-inch and 36-inch ranges
will use three (3) screws and 48-inch range will use four (4)
screws.
Install four (4) screws to secure the backguard's back panel
to the guide channels on the back of the range. Install one
(1) screw and spacer to center hole location. (See
Figure 14.)
The spacer is necessary to create proper clearance
between the backguard rear panel and the back wall. The
spacer is not used with the Island Trim.