VITO AGRO VIBTI800A Mode D'emploi page 26

Question/Problem - Cause
Cause
The pump won't turn on:
• The power cord is not plugged in or there is an
electrical fault;
The pump turns off suddenly while it's working:
• The heat sensor shut the pump down because it was
overheating;
The pump starts but does not pump any water:
• The pressure hose is bent or clogged;
Not enough water is being transported:
• The pump's power is reduced due to the water being
extremely dirty and mixed with abrasive substances;
The pump automatically shuts off after it has only been
running for a short amount of time:
• The protective feature installed within the motor
shuts it off due to the water being excessively dirty;
• The temperature of the water is too high, so the
engine's internal protection turns it off;
Solution
• Check the plug, socket and circuit breaker of the supply
circuit;
• While the pump cools down, unplug the power cord
and clean the turbine;
Do not let the temperature of the water exceed 35°C;
• Insert the hose correctly and clean it;
• Clean the pump and any worn parts;
• Remove the plug from the electrical outlet and clean
the pump and well;
• Do not let the temperature of the water exceed 35°C;