Westfalia 88 25 28 Mode D'emploi page 18

 Do not exert pressure on to the tool. To do so would shorten
its service life.
 If you are interrupted when operating an impact driver,
complete the process and switch off before looking up.
 Where possible, use clamps or a vice to hold your work.
 Examine the bit holder regularly for signs of wear or damage.
Have damaged parts repaired by a qualified service centre.
 Always wait until the impact driver has come to a complete
stop before putting it down.
 Periodically check all nuts, bolts and other fixings and tighten
where necessary.
 Only use bits and accessories, specifically designed for use
with impact drivers. Conventional bits and accessories may
shear off during use, or be otherwise damaged, potentially
ejecting dangerous projectiles.
 Ensure that fasteners are suitable for impact driver use. Nuts,
bolts and screws that are not suitable for high torque applica-
tion may be damaged.
 Have your power tool serviced by a qualified repair person
using only identical replacement parts. This will ensure that the
safety of the power tool is maintained.
Additional Battery and Charger Safety Notes
WARNING: Li-Ion batteries, if incorrectly used, stored or charged
are a fire, burn and explosion hazard.
Use the battery charger correctly
 Refer to the section of this manual relating to use of the battery
charger before attempting to charge the battery.
 Do not attempt to use the charger with any batteries other than
those supplied. Failure to follow these instructions may cause
overheating or fire.
 When battery pack is not in use, make sure the battery pack
cannot be shorted accidentally. Keep the battery clean at all
times. Keep it away from other metal objects, like paper clips,
Safety Notes
14