Inglesina NEWTON I-FIX Manuel D'instructions page 30

with the strictest approval criteria compared with previous models that do not
feature this warning.
• Do not use the Newton 1.2.3 IFIX child car seat if:
- it was subject to accident, even to a slight one. It may have been subject to
invisible damages. The child car seat has to be replaced with a new one to
assure the safety level.
- it is damaged, not equipped with the instruction manual, or any component
is missing. Contact the Inglesina authorized Retailer or Customer Care
Service immediately.
- if it is second-hand. There could be extremely dangerous structural damage.
• Check to make sure that all the components of the child car seat are properly
hooked before every trip and/or if the vehicle has undergone periodical tuneups,
maintenance or cleaning. Someone could have tampered with and/or unhooked
the child car seat and not repositioned it correctly according to the instructions.
• Avoid inserting fingers inside mechanisms.
• The Newton 1.2.3 IFIX child car seat is a Universal ISOFIX restraint device when
used as Group 1 in vehicles equipped with ISOFIX connectors and Top Tether
connection.
• In this configuration never use the child car seat without Top Tether because it
is essential for guaranteeing complete safety.
• Car use of the Newton 1.2.3 IFIX child car seat is intended only for vehicles
equipped with 3-point seat belts with winders, approved in compliance with
regulation UN/ECE 16 or other equivalent standards. Check the instruction
manual of the car to see in which positions the child car seat can be installed. In
case of doubt, contact the Manufacturer or authorized Dealer immediately.
• Do not use the car's two-point or lap safety belt.
• In order to ensure the car's safety belts are passed correctly, periodically check
and adjust the position of the backrest and the headrest and adapt them as the
child grows.
• The Newton 1.2.3 IFIX child car seat can be fitted on most cars with Isofix
anchoring points. However, check the compatibility on the relative list of vehicles
on which it can be applied.
• THE CHILD CAR SEAT MUST BE INSTALLED IN
STRICT COMPLIANCE WITH THE INSTRUCTIONS
PROVIDED. FAILURE TO OBSERVE INSTRUCTIONS/
WARNINGS CAN SERIOUSLY COMPROMISE YOUR
CHILD'S SAFETY.
• The child car seat must be assembled and fitted when the child is not in it.
• Do not place any padding between the base of the child car seat and the
30
GROUP 1
GROUP 2/3
USE AND INSTALLATION