Publicité
Les langues disponibles
Les langues disponibles
Preparation
Important: When using an existing outlet box, be sure the box is securely attached
to the building structure and can support the full weight of the fan. Failure to do
so can result in serious injury or death.
1
Step 1
Turn off circuit breakers and wall switch to the fan
supply line leads.
Warning: Failure to disconnect power supply prior to
installation may result in serious injury or death.To reduce
the risk of shock, this fan must be installed with an
isolating wall control/switch.
2
Check to make sure blades are at
least 30" from any obstruction.
Check downrod length to
ensure blades are at least
7' above the floor.
Step 2
84"
(2.1m)
Min.
3
Prior to securing mounting bracket, screw "J" hook (S9) into ceiling outlet
box as a secondary support means. Secure mounting plate (#1) using screws
and washers (S2) directly to the outlet box. If not mounting to an outlet
box, use wood screws (S1) and mount securely to a beam or joist.
NOTE: Do not mount directly to sheet rock or ceiling tile.
NOTE: J Hook installation is a Canadian requirement only.
"J" Hook (S9)
Ceiling
30"
0.75m
Min.
4
Hang the fan motor/mounting bracket (#2) onto the hook that is positioned
on the mounting plate (#1).
Mounting Plate (#1)
Fan Motor Mounting Bracket (#2)
Step 3
Support Beam
OUTLET BOX
Mounting Plate (#1)
Wood Screws
& Washers (S1)
Screws & Washers
for Mounting Plate (S2)
Step 4
Publicité
