Arcam CD72 Mode D'emploi page 4

Installation
Positioning the unit
Always place the CD player on a level, fi rm surface. Placing
your player on a set of dedicated sorbothane isolation feet
will isolate the unit from its surroundings as well as absorbing
the vibrations created within the player itself. You will generally
hear some sonic improvements, which makes this an extremely
cost-effective upgrade.
Connecting to other equipment
Interconnect cables
Interconnecting cables are not supplied with this CD player. We
recommend high quality cables as inferior quality cables will
degrade the sound quality of your system. Please contact your
Arcam dealer for details of suitable cables.
Audio outputs
Connect these to your amplifi er's CD or any other line-level
input using suitable high quality interconnect cables. Ensure
that the left and right audio outputs from the CD player are
connected to the same left and right inputs on your amplifi er.
CD92 only: The second set of sockets can be used to
connect to a second amplifi er set up for multi-room use.
Coaxial digital output
Use this socket if you are using a separate digital to analogue
converter (DAC) or digital recorder. Connect to the DAC or
recorder's digital input using a suitable 75Ω screened cable.
CAUTION: Never connect the digital output socket to a
conventional audio input.
Optical digital output
Use this socket if you are using a separate DAC or digital
recorder with an optical connection. Connect using a suitable
optical cable.
CD72 rear panel (part)
230V
DIGITAL OUTPUTS
POWER INLET
CO-AXIAL
OPTICAL
1 2 3
1
Power inlet, with voltage indicator
2
Coaxial digital output
3
Optical digital output
4
Single audio output
5
Remote input
CD72/92
4
All manuals and user guides at all-guides.com
AUDIO OUTPUT
REMOTE
IN
R L
4 5
Remote input connection
It is not necessary to make any connection to this socket in
normal use. This connection is for ease of installation to multi-
room remote control systems and is suitable for modulated
IR commands. Contact your multi-room installer for more
information.
Connecting to a power supply
Wrong plug?
Check that the plug supplied with the unit fi ts your supply and
that your mains supply voltage agrees with the voltage setting
(120V or 230V) indicated on the rear panel of the unit.
If your mains supply voltage or mains plug is different, consult
your Arcam dealer or Arcam Customer Support on +44
(0)1223 203203.
Mains lead
The appliance is normally supplied with a moulded mains plug
already fi tted to the lead. If for any reason the plug needs to
be removed, it must be disposed of immediately and securely,
as it is a potential shock hazard when inserted into the mains
socket. Should you require a new mains lead, contact your
Arcam dealer.
Plugging in
Push the plug (IEC line socket) of the power cable supplied with
the unit into the socket (
POWER INLET
Make sure it is pushed in fi rmly.
Put the plug on the other end of the cable into your power
supply socket and switch the socket on.
CD92 rear panel (part)
230V AUDIO OUTPUTS
DIGITAL OUTPUTS
1
POWER INLET
CO-AXIAL
OPTICAL
1 2 3 4
1
Power inlet, with voltage indicator
2
Coaxial digital output
3
Optical digital output
4
Twin audio outputs
5
Remote input
) in the back of the unit.
L
REMOTE
IN
R
2
5