Torin BIG RED T10152D Manuel Du Propriétaire page 7

OPERATION
BEFORE USE
1. Before using this product, read the owner's manual completely and familiarize yourself thoroughly with the
product and the hazards associated with its improper use.
2. Check and that the jack operates smoothly before putting into service.
3. Inspect before each use. Do not use if bent, broken or cracked components are noted.
OPERATION
RAISING THE JACK
1. Position the jack near desired lift point.
2. Insert the jack handle into the hole of the handle
socket.
To prevent damage to the jack, do not move the
jack while the handle is attached to the socket.
3. Secure the handle in place inside the handle
socket. Without any weight on the jack. Cycle the
lift up and down several times to insure the jack is
operating properly.
4. Before raising, double check and verify the saddle
is centered and also has full contact with the lifting
point.
5. Grasp the handle firmly with both hands. Securely
hold on to the jack handle so your hands do not
slip.
6. To raise load, turn handle clockwise.
7. After lifting, support the load with support stands
before working under any load.
CAUTION: NEVER WIRE, CLAMP OR
OTHERWISE DISABLE THE LIFT CONTROL
TO FUCTION BY ANY MEANS OTHER
THAN BY USING THE OPERATOR'S HAND.
USE THE HANDLE PROVIDED WITH
THIS PRODUCT OR AN AUTHORIZED
REPLACEMENT HANDLE TO ENSURE
PROPER RELEASE OPERATION.
WARNING: USE EXTREME CAUTION
WHEN LOWERING THE JACK. FAILURE TO
HEAD THESE WARNINGS COULD CAUSE
SERIOUS INJURY OR DEATH.
All manuals and user guides at all-guidesbox.com
LOWERING THE JACK
1. Insert the jack handle into the hole of the handle
To prevent damage to the jack, do not move the
2. Grasp the handle firmly with both hands. Securely
3. Raise load high enough to allow clearance for
2. Secure the handle in place inside the handle
3. To lower load, turn handle counter-clockwise.
4. After removing jack from under the load, lower the
7
socket.
jack while the handle is attached to the socket.
hold on to the jack handle so your hands do not
slip and ensure the release valve does not rapidly
lower.
the support stands to be removed, then carefully
remove support stands.
socket.
saddle completely.