Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
When rigging, derigging or servicing the pinspot, staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The pinspot should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the pinspot. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The pinspot has to be installed out of the reach of people.
If the pinspot shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The pinspot must never be fixed swinging freely in the room.
Caution: Pinspots may cause severe injuries when crashing down! If you have doubts concerning the safety
of a possible installation, do NOT install the pinspot!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the pinspot's
weight.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Mount the pinspot with the mounting-bracket to your trussing system using an appropriate clamp. The hole in
the mounting bracket has a diameter of 10 mm.
For overhead use, always install a safety-rope that can hold at least 10 times the weight of the fixture. You
must only use safety-ropes with screw-on carabines. Pull the safety-rope through the hole in the mounting-
bracket and over the trussing system etc. Insert the end in the carabine and tighten the fixation screw.
Adjust the desired inclination-angle via the mounting-bracket and fix the bracket-screws tightly.
Connect the fixture to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
DANGER OF FIRE!
International
L
N
11
Publicité
Table des Matières
